Door Speaker Enclosure Prototype
#31
Guest
Posts: n/a
Hey Shooter - I bit the bullet and decided to start out on my bose stereo upgrade - I am going to start with 6.5" MB Quarts in the front...more later.
If you wanted to get measurements from the Sedan front for your 3d project, I'll let you know when I am doing the install and you can drop by - a little self-interest here
If you wanted to get measurements from the Sedan front for your 3d project, I'll let you know when I am doing the install and you can drop by - a little self-interest here
#33
#34
hopefully there is more room in the sedan between the window and the door panel so a larger enclosure can be made that will fit through the speaker hole in the door panel....the biggest enclosure i could make for the coupe was not big enough to do any good (it fit through the speaker opening).........i am trying to come up with a 2 piece enclosure, 1 part will fit through the speaker hole in the door panel and attach to the second (larger) part that will be installed from the back side (the access panel will have to be removed for this design.........gonna take a while to design and build a prototype tho....still modding the engine for now
Thread
Thread Starter
Forum
Replies
Last Post
DEMoLITIoN
Audio/Video/Electronics
8
04-20-2016 06:57 PM
FS[SoCal]: D/S 4080 Enclosure & JL Audio W6v2 10 inch
MrIP35
Audio/Video/Electronics
9
11-08-2015 10:47 AM
Extreme Dimensions
Southern California
3
10-19-2015 06:28 PM
3d, 65, door, enclosure, enclosures, guards, indoor, inside, isothermal, mdf, printed, prototyping, putting, speaker, splash