DIY: Cutting Rear Springmount aka "the springmount mod"
#185
#189
Alright so I am considering this mod.
In the front I measure from the wheels to the top of the fender, the front is about even 2 ft 2 inches from the ground.
but the passenger rear is about 2 ft 3 inches, so its about an inch different from the front, and the driver rear is about 2 ft 3 1/4 inches so its about 1 inch and a 1/4
I am guessing the passenger side is because I always keep a full gas tank in it...
Should I cut about an inch? or 3/4? i donno...
In the front I measure from the wheels to the top of the fender, the front is about even 2 ft 2 inches from the ground.
but the passenger rear is about 2 ft 3 inches, so its about an inch different from the front, and the driver rear is about 2 ft 3 1/4 inches so its about 1 inch and a 1/4
I am guessing the passenger side is because I always keep a full gas tank in it...
Should I cut about an inch? or 3/4? i donno...
#191
#193
Anyone know of a good place to have this done in the 818/626?
Or better yet willing to help me?
I prefer to do most of my own work on my ride but I don't have any of the tools req.
The vice would be the real pain to get.
The underground parking in my apt doesn't have the best light either.
Or better yet willing to help me?
I prefer to do most of my own work on my ride but I don't have any of the tools req.
The vice would be the real pain to get.
The underground parking in my apt doesn't have the best light either.
#195