bump

 

Nobody has run into any problems still, right? Been wanting to do this for a while but wasn't sure.

 

Here's before, during, and after. I will get some full side shots tomorrow.

 

^^^ o snap looks good matt..im waiting for my drop in the mail hehe

 

We've been doing this mod for years, with no problems.

 

do you need to do this for 350z stechs?

stechs go lower then htechs right?

 

stech goes lower. I've seen a lot of people do the mod on 350z stech, but so much on the g35 stech.

 

so the 350z stechs go lower then the g35 stechs?

 

Alright so I am considering this mod.

In the front I measure from the wheels to the top of the fender, the front is about even 2 ft 2 inches from the ground.

but the passenger rear is about 2 ft 3 inches, so its about an inch different from the front, and the driver rear is about 2 ft 3 1/4 inches so its about 1 inch and a 1/4

I am guessing the passenger side is because I always keep a full gas tank in it...

Should I cut about an inch? or 3/4? i donno...

 

more than half-inch is a lot.

 

Yeah?

Should I do 1/2" and 3/4" to even out the rear?

I tink that sounds good, because when people sit in the back it should be dead even in frt/rear I believe...

any toughts?

 

^give yourself 1/4" padding. So if you measured that you need 3/4" drop then cut 1/2".

 

Anyone know of a good place to have this done in the 818/626?
Or better yet willing to help me?
I prefer to do most of my own work on my ride but I don't have any of the tools req.
The vice would be the real pain to get.
The underground parking in my apt doesn't have the best light either.

 

so if i cut more than half of the mount, how bad would that be? or would that be too much of a drop? sitting on 350z stech

 

im on g stecs and the passenger rear is sitting noticably higher than the driver rear now that they've settled. i know some people have this problem. has anyone cut just the rear passenger side to even out the drop?