350z H-techs before and after pix FINALLY

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Jan 23, 2007 | 04:59 PM
  #76  
redlude97's Avatar
Registered User
iTrader: (25)
Joined: Feb 2006
Posts: 1,911
Likes: 8
From: Seattle, WA
Originally Posted by Slick 6MT
So did you get a camber kit to get rid of the terrible negative camber you had in the rear or did you just get an alignment?

Looks good!
I have purchased a camber kit for the rear, but haven't installed yet. Its been too cold and I've been busy with school. The pic with the sp1s is with the uncorrected camber, and it looks fine to me, but I'm going to dial out some of the negative camber once I get my SPC kit installed.
 
Reply
Old Jan 23, 2007 | 06:37 PM
  #77  
Slick 6MT's Avatar
Registered User
iTrader: (15)
Joined: May 2005
Posts: 1,600
Likes: 6
From: NJ/FL
Originally Posted by redlude97
I have purchased a camber kit for the rear, but haven't installed yet. Its been too cold and I've been busy with school. The pic with the sp1s is with the uncorrected camber, and it looks fine to me, but I'm going to dial out some of the negative camber once I get my SPC kit installed.
So you haven't had an alignment since you put the h-techs on with the rear spring mount cut?
 
Reply
Old Jan 24, 2007 | 01:25 AM
  #78  
redlude97's Avatar
Registered User
iTrader: (25)
Joined: Feb 2006
Posts: 1,911
Likes: 8
From: Seattle, WA
Originally Posted by Slick 6MT
So you haven't had an alignment since you put the h-techs on with the rear spring mount cut?
No, but I only drive my G once a week at most, its been sitting in the lot almost all the time since I moved to Seattle where I walk everywhere, I've only put maybe 700 miles on it in the last 2-3 months
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
VatoVazq
Steering & Suspension
16
Jan 3, 2025 11:08 PM
THMotorsports
Suspension-Vendor
257
Dec 18, 2018 05:43 PM
andrewvk
Engine - Complete Motors
32
Apr 7, 2016 01:39 PM
DRG35R
Wheels & Tires
19
Jan 31, 2016 07:14 AM
9tray turbo
Media Share G35 Coupe V35
4
Sep 29, 2015 10:22 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 04:14 PM.