Akebono swap
#1
Join Date: Dec 2008
Location: Northern Virginia
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
#4
#5
Join Date: Dec 2008
Location: Northern Virginia
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
Well I knocked it out yesterday by myself in about 5 hours, slacking and taking my time to read and re-read the article you linked me too. Unfortunately since I was the only one working on it, I was more focused on doing the work and doing it right, rather than documenting it with pictures. I did have help at the ended bleeding my brakes since it is easier with two people.
I would estimate that if I had a lift and multiple airsaw blades for cutting the dustshields, the job could be done in about 3.5 hours. 2 if you had two people working at the same time. It is an incredibably easy job to do.
I would estimate that if I had a lift and multiple airsaw blades for cutting the dustshields, the job could be done in about 3.5 hours. 2 if you had two people working at the same time. It is an incredibably easy job to do.
#6
Fine, make me more envious why don't you!
And I wasn't thinking of another DIY from you, nothing that big. Maybe just add your thoughts on your upgrade to that DIY thread so others might benefit.
Now, where's that template I cut out? I'm sure if I measure it just one more time against those stock 17's, it will finally fit.
And I wasn't thinking of another DIY from you, nothing that big. Maybe just add your thoughts on your upgrade to that DIY thread so others might benefit.
Now, where's that template I cut out? I'm sure if I measure it just one more time against those stock 17's, it will finally fit.
#7
Hey Guys,
Just wanted to post this up...I received my front adapter brackets for the Akebono BBK swap the other day from Fueled Racing (http://www.fueledracing.com) and these things are SWEET !
https://www.dropbox.com/s/txrnlrivrm0bme4/DSC_0041.JPG
Just wanted to post this up...I received my front adapter brackets for the Akebono BBK swap the other day from Fueled Racing (http://www.fueledracing.com) and these things are SWEET !
https://www.dropbox.com/s/txrnlrivrm0bme4/DSC_0041.JPG
Last edited by GreySky; 06-20-2014 at 04:42 PM.
Trending Topics
#9
Super Moderator
iTrader: (3)
For anyone doing a repaint on the Akebono's and needs the lettering I just found this place... http://www.acromann.com/product_info...d50j5rp4u8hfc2
/troll
Seriously though, that looks good... But we need you to test them to temperature cycles (getting hot and cold).
The following users liked this post:
GreySky (06-22-2014)
Thread
Thread Starter
Forum
Replies
Last Post