Front camber install problem
#1
Front camber install problem
So yesterday i was installing my coilovers and decided to install my SPC front camber arms too.
Well when i unbolted the bolt to the spindle on the driver side, the arm WOULD NOT come out of the spindle. Me and my friend literally hammered the crap out of thr bolt hoping it would come out. Any ideas how to remove it? We applied pressure and everything, still no go.
I then went to the passenger side and took the bolt off that spindle and hammered the bolt a little and it popped off!
Any suggestions to getting that part off the spindle? Any one else run into the same problem as well?
Thanks guys
Well when i unbolted the bolt to the spindle on the driver side, the arm WOULD NOT come out of the spindle. Me and my friend literally hammered the crap out of thr bolt hoping it would come out. Any ideas how to remove it? We applied pressure and everything, still no go.
I then went to the passenger side and took the bolt off that spindle and hammered the bolt a little and it popped off!
Any suggestions to getting that part off the spindle? Any one else run into the same problem as well?
Thanks guys
#3
I would try jacking the whole assembly up and down a bit to change the angle; it may just be binding in there. Also, instead of hammering on the bolt, rap the side of the a-arm. Another option would be to rent/borrow a picklefork which you tap in between the spindle and the a-arm to wedge the joint apart. Works kinda like this:
#5
#6
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
netcbc
Steering & Suspension CDN
0
07-24-2015 01:59 PM