Specs are BC 88mm crank, BC rods 96.5 JE 11.0.1 pistons Ported and polished head 5 angle valve job on +1mm Manley valves and Jim Wolf S7 cams.

http://my350z.com/forum/na-builds/51...-na-build.html

All ARP fasteners, Forged girdle, ARK knockoff large oil pan

I have over 12k in this a stock low mile motor commands 3k. Looking for 5k plus actual shipping.





No front cam solenoid




Cylinder 2 was viewed through a scope and appears to have lost a piece of the top. The crank is ok, the rod is ok.

I will have a picture from the scope later.

 

holy crap, glws that is amazing

 

 

So whats thw deal with it? Missing? Please explain. Thanks

 

It was using oil and the #2 plug was covered in oil. We opened the oil pan and I took the pictures I posted. The lower bearing has minimal scoring, the crank none. The upper was tightly installed and would not come out.

At a minimum it needs a piston and it's rings. If I were going to deal with it I'd pull the crank and all pistons and be prepared to replace the rings and bearings.

 

Cyl 2 is the damaged piston.

Plugs:

1-4




3-6

 

Offers, reasonable part out requests (don't ask for a valve)

 

would u part out cams?

 

No sorry complete heads yes but not disassembling them.

Sale pending on complete longblock.

 

Just curious whats the best price you could do for both complete heads?