you dont need the code....you can do a hard reset on the UTEC which will set it back to factory specs and remove codes/maps that are on there already

http://turboxs.com/uploaded_images/553.pdf <<<--- This is the installation manual which has instructions on the reset
go to page 54

You are going to download the latest versions and FLASH them to the UTEC as if you were upgrading. It will over-write all the information and reset the UTEC so you can use it.

 

its not that tough. let me know if you have other questions.

 

That is exactly what I told you to do, you need to reset the utec. Then there will be no pin. Once it is reset then they can load a base map and make adjustments to the map accordingly.

 

Thanks guys, I'm at my tuner now, Olympic Motorsports. This guy is awsome.. Really cool. And has it all figured out....

 

Ok I'm trying to find program
M16c_flash_v122.exe

I need this to uplode to
Reflash!!'

 

its on the TurboXS site.

http://turboxs.com/utec350zupdate.htm

all the stuff that you will need is there - including a few base maps for a tuner to "start" from

 

We found them but couldn't get them loaded on the utech. It was very time consuming but we finally or it done. Now we loaded the base maps and turned the car on and now it doesn't turn on. Pulled the codes
P112 something like thatz Tps sensor stuck open.. So car couldnt be tuned car would start and bog down right away.... Now I need a new Tps....

 

it seems to me your just having a bad F/I experience all around...lol

 

so we spent about 8 hours getting everything set and now the cars tps sensor is bad. the car starts and just shuts off. what else can it be? the code said throttle positioning not function or something... so im sure that is it..but just to cover all my grounds and i can research it until monday, what else can it be?

 

TPS is inside the Throttle Body

if you jacked with that at all while it was plugged in and connected to the battery its possible you tweaked something.

Put it in MAP 0 (runs off ECU only) and do a idle volume relearn procedure reset as well as the throttle closed position learning. do a search, if you dont know how to do it.

 

We did that as well but the Tps code just kept comming back... So I'm guessing it's that... I cant think of anything else it can be....

 

what code are you getting?

 

I'm getting a p0112 I think, I don't remember exactally... But it did say TPS...

 

try swapping with someone who is local. if its the throttle body its a quick swap to test.

 

The car basically turns on.. We try to rev it and no throttle response... Then it just bogs down and cuts off... It will do this everytime.
Isn't that a symptom
Of Tps going bad??