I’m looking to run a new ground wire from my crankshaft sensor to my battery. Does anyone know an easy way to run that ground? Not sure how to get from the sensor/bell housing area to the battery area.. Any advice would be helpful

 

Replied to your pm. I'll try to see if I have any pics, I just had my tranny out a couple weekends ago and was taking pics of other things.

 

Here's a bunch of random pics I found, personally I think you're PROBABLY best off with zip tying onto that harness right next to the CKP and going forward under the headers on the driver side, I don't know exactly what that harness leads to but it goes up at some point. Remove the engine bay lower plastic cover and there will probably be some big obvious place to go up. If not then on the passenger side on the battery box there are a couple of fuel or evap lines that run right down near the starter, if you can jump over to the starter somehow then you definitely have a way up.