dont have my custom gauge face yet so just testing with the stock one on, it's got a yellow tint that will still show even with white leds behind it. i am putting the radar detector where the rev light is so i just put a random blue led there since it wont be seen, might just replace it with a 0ohm resistor

 

new map/dome light plus i added some led from diode dynamic.

 

Unfortunately there may be a color screen.

 

that fitment

 

Cleaned out the whole interior, wash, rotary polish, wax, windows cleaned, center console cover ripped to shreds, and e-brake adjusted to stop the car when Jesus takes the wheel.

 

Finally put in my new radio, only had one casualty.. This is a normal thing so I laughed about it when the piece flew past my head.. Every time I fix one thing something else breaks.. Luv my car

 

Mine didn't bust like that, but all clips broke off. 10 years of interior heat really weakens that plastic. Oh well. Got a new one, now I got 10 yrs before my new one breaks.

 

Yeh no biggie.. Already ordered a new one lol

 

sigh....if only real life were as easy as photoshop....

 

Gotta lift at an angle I recall

 

I watched how to do it on youtube and even have the rubber interior tools.. lol I have the worst luck..

 

cleanest dual ring tail light setup? this one will replace the stock controller board, has an extra port for the extra ring so it will be plug n play. also has an extra port to integrate the turn signal wire and will have the second ring work as the turn signal. and also an extra port for an led drl for the light on the side. like the sedan

 

Just make it "easy" to install and I am really interested.

 

^^^I second this and you will have my money!