What did you do to the G today?
#7381
PM sent on the springs. I highly recommend you take the shocks too!! Pic of the car on the springs attached
The following users liked this post:
lasen72 (06-23-2017)
#7382
Yesterday I changed the oil, degreased and pressure washed the engine bay and under car, fixed the headlight, recharged the AC. And also removed 1" from the rear spring isolator to level the drop on the Bilstein/Eibach Pro Kit 350z suspension. No more rake! Yeaaaa
Today I drove it and enjoyed it
Today I drove it and enjoyed it
The following 2 users liked this post by EPiK:
Blue Dream (06-25-2017),
lasen72 (07-01-2017)
#7383
#7385
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,299
Received 1,487 Likes
on
1,222 Posts
G35 sedan w/ too much money in mods
#7386
#7387
Yesterday I changed the oil, degreased and pressure washed the engine bay and under car, fixed the headlight, recharged the AC. And also removed 1" from the rear spring isolator to level the drop on the Bilstein/Eibach Pro Kit 350z suspension. No more rake! Yeaaaa
Today I drove it and enjoyed it
Today I drove it and enjoyed it
#7389
#7390
dropped her off at Infiniti, my extended warranty runs up in a few months.
So far being replaced:
-Fuel pump ($400+ part)
-Power steering rack ($1,900+ part)
-Driver's side window motor ($200+ part)
-Re-seal the passenger's side axle (unsure of cost, sure labor will be a lot)
-Entire Gauge cluster (set light on cruise control doesn't turn on) (lol don't even want to take a gander)
I miss my baby.
So far being replaced:
-Fuel pump ($400+ part)
-Power steering rack ($1,900+ part)
-Driver's side window motor ($200+ part)
-Re-seal the passenger's side axle (unsure of cost, sure labor will be a lot)
-Entire Gauge cluster (set light on cruise control doesn't turn on) (lol don't even want to take a gander)
I miss my baby.
#7392
dropped her off at Infiniti, my extended warranty runs up in a few months.
So far being replaced:
-Fuel pump ($400+ part)
-Power steering rack ($1,900+ part)
-Driver's side window motor ($200+ part)
-Re-seal the passenger's side axle (unsure of cost, sure labor will be a lot)
-Entire Gauge cluster (set light on cruise control doesn't turn on) (lol don't even want to take a gander)
I miss my baby.
So far being replaced:
-Fuel pump ($400+ part)
-Power steering rack ($1,900+ part)
-Driver's side window motor ($200+ part)
-Re-seal the passenger's side axle (unsure of cost, sure labor will be a lot)
-Entire Gauge cluster (set light on cruise control doesn't turn on) (lol don't even want to take a gander)
I miss my baby.
#7393
Ok, the (almost) final product following install of Fortune Auto coilovers with Swift springs and Z1 A arms.
It seems like the springs settled a bit after install, so we raised it 0.5" today to give some clearance.
The Fortune Auto coilovers are REALLY GOOD. I got the swift springs at their recommended 10k/8k ratings, however, if I were to do it again I think I would go 12/10 for a bit firmer ride.
Next up is cosmetics...but I'll take a bit of time off before then. Next year I think will be dyed carpet to black and new seats. The seats are a big problem for handling performance because the worn out bolsters provide almost no lateral support.
It seems like the springs settled a bit after install, so we raised it 0.5" today to give some clearance.
The Fortune Auto coilovers are REALLY GOOD. I got the swift springs at their recommended 10k/8k ratings, however, if I were to do it again I think I would go 12/10 for a bit firmer ride.
Next up is cosmetics...but I'll take a bit of time off before then. Next year I think will be dyed carpet to black and new seats. The seats are a big problem for handling performance because the worn out bolsters provide almost no lateral support.
#7394
Entered into a show today and won my first trophy. Runner up 2 door import, not bad for my first legit show. Also, I was drooling over this Raptor that was in the booth with us. Those tires are 375mm wide, thing was so sexy. And somehow my passenger headlight is getting some condensation in it, which unfortunately ruined all the bulbs which I'm not stoked about.