where can i get a m45 engine? are you guys sure that it will fit?

you have got to be kidding. i know you are. you are kidding. you are kidding. you are making a joke. haha funny.

ok, let's get a little more down to business. let's start with a shopping list - what is your plan?

Chris Shively from my crew on 16niss rebuilt the VQ35. AEBS stroker kit and went from a 3.5 liter to a 4.3 liter. here is the list of his mods.

AEBS VQ35 4.3 Custom Stroker Kit
- AEBS Pro Spec T-Sleeves
- AEBS Custom Stroker Crank Shaft
- Pauter Custom Stroker EDM Drilled Rods
- ROSS Custom Stroker Pistons 8:5.1/100mm
- AEBS Final Bore and Hone
- ARP Custom VQ35 12mm Head Studs, Nuts, and washers
- ARP Main Studs
- Greddy Oil Catch Can
- Light Speed Performance Stage 3 Race Heads
- Tilton Twin disk Carbon/Carbon Clutch
- SSR Engineering Twin Turbo Kit with two hybrid Turbonetics Ball Bering T3 super 60 turbos
- SSR Engineering custom Intake Manifold
- Unorthodox Racing 3 piece pulley set
- Autronic stand alone ECU with LCD screen
- NISMO Rear Differential Cooler
- Chroming from Hard Pipes.com
- Precision 1600cc Fuel Injectors
- NISMO RB26 oil pump with gears and a housing designed to mate to the VQ35
- Brisk Racing Spark Plugs
- NISMO Low Temperature Thermostat
- Kazz 2.0 way with 1.5 way upgrade rear diff
- Greddy Radiator Breather Tank
- Tomei 268/10.5 in/ex camshafts
- Accufab 90mm Throttle Body
- NISMO High Strength Valvespring Set
- B&M Short Shifter

here are some pics of that engine

That's unreal.

+1 for some sort of NA build... ...even a stroker. If you're still wanting more power, nitrous would be a minimal expense that the engine is already prepped for.

What type of power is that thing putting down?

Best looking 350 I have ever seen. That motor is over the top .

with that engine plus the turbo's... ALOT!

sooo now i have alot of long extensive research to do... i am seriously going to consider the m45 engine swap! i will have my full complete plan and what im going to do step by step in about 2 or 3 weeks.. ill keep you posted

If you go with the stroker kit and FI you will need to go with a full stand alone (at least $5K). There are a few guys on my350z that have gone that route. You are looking at $50K just in the motor......that is ridiculous. Keep in mind I have almost $30K in my car (motor, rims, body kit, etc.) but $50K just in the motor I dunno.....

Hey good luck with your project.

I dunno, if it were me, I'd just buy a faster car and be done with it.

Any suggestions? Not counting eye candy mods, I only have $19K in the motor. $35K for the car + $19K = $54K. What car can you buy for $54K that has over 500hp at the wheel and will do the 1/4 mile anywhere from 11.5-11.8?

the yellow Z should push around 1200 hp