Okay so I replaced the clutch on my g35 6mt sedan, followed direction by direction, had pictures taken of the process so that I knew what went where but it the girl just wont start... I don't know if there is a trick to it or what but if anyone has ran into a similar problem and/or knows a solution It would be greatly appreciated!

 

Won't start As in cranks and cranks but won't fire?

Or it won't crank over at all?

 

did u line up the little dowel little thing on the flywheel


edit:

http://my350z.com/forum/forced-induc...h-install.html

 

^that shouldnt matter

even if the transmission isn't lined up correctly the engine should still crank over

 

u might of messed up the crank sensor if u didnt pull it out before taking off the tranny. if u did pull it out, make sure its in and connected properly.

 

Yes it'll crank but won't fire.
I'll check the sensor tomorrow.
I'll keep you all updated.
Thanks g's.

 

Def let us know.

 

Look for a dot on the sides of your flywheel. When you install the flywheel, the crank position sensor should be right on it.

 

It was the crank sensor, I didnt tighten it enough I suppose.
Thanks G's!

 

glad to hear its working! these peeps almost always point you in the right direction