Does anyone know how to easily pull the rear quarter on a g sedan? Ali pulled the fronts with my Eastwood very easy but the quarters are praising me off. Drivers side pulls pretty good but the passenger is not. Granted the passenger side has body work but was done right but it's like the roller is hitting the inner fender also with the lip of the quarter. Thinking about cutting it out some. What do you guys think?

 

On the sedans, is there a bump in the fender lip? Where the corner of the door is? If there is, how are you working with it? I actually have an FX, but the rear door/quarter junction is pretty much the same as the G sedan. I've rolled the fenders flat, but there is a bump there that will not roll flat. I've even tried to flatten it with a hammer, but no good. So now the tires hit that bump.

 

Do you have a picture of it? I have not heard or seen something that is a "bump".

 

So I had to give up on the fender roller on the quarters. It just wasnt working. So I had to alot of metal working. Used my stud welder and also my hammer and dolly. I was able to pull it very well. I have to put some body filler in it but knew I would have to so was not a issue for me. Here are some pics

 

Looks good.

Will try to find a pic. But right where the door curves and comes to a point. The quarter on the fx has some reinforcement. Didnt know if the g had that as well since the door line looks the same.

 

Def get a pic. You may just need to cut the reinforcement out

 

Not bad!!! How long it took you to do that

 

The metal work took maybe 3 hours and smoothing everything out took about another 3 hours. It's time consuming but well worth it in the end

 

That's what up

 

Nice! saw this on instagram, stoked to see it skimmed and sprayed.

 

It's not sprayed yet. It's just plasti dipped for right now until I can finish it up tomorrow and prime it. Will paint both quarters sometime this month

 

Nice work!!