I have a 2007 g35s sedan and yesterday I was driving at about 35 slowing down for the car in front of me to turn. When I hit about 25 I felt a slight jerk but didn’t think much of it. Once the car turned and I went to speed back up when I realized the car was running horribly. I looked at the dash and the VDC and slip light are on. This morning I replaced all 4 camshaft position sensors and had no difference. I haven’t been able to scan for codes yet but I have a buddy come to help me later. Anything helps

 

Anything

 

You have to top up your brake fluid as full as it will get and then both those lights will disappear I had the same problem when I bought mine but just fill your brake fluid up all the way.

 

I finally got the car scanned and I have a p0345 cps code. I’ve already replaced all cps but they came out of my parts car that’s sat outside without a hood on it so idk if they’re still good. And the car still runs the same.

 

would this make the car run bad?

 

Yes

 

yeah it can mess with your brakes in a couple ways and it could possible damage some sensors if you overfill your brake fluid so maybe get the lights off and then pump it out

 

I bought a new cps and replaced the driver side intake sensor and still the same

 

I’ve been looking online and can’t find anything I’m thinking it might be the wiring or the computer because I put new sensors in and nothing changed. I then unplugged the sensor that was showing a code and nothing changed which makes me think that the sensor isn’t getting any power. If anyone had a wiring diagram that showed what pins control the 4 different cam sensors on the computer that would be very helpful. I want to make sure there is no breaks in the wires but idk what pins are associated with the sensors