Injen CAI Problem
Need Help!!!!! I just installed a Injen CAI in my 04 coupe. It seems to be ok at idle and low rpm and speed. But when I floor it from a dead stop, it shuts off right when it reaches about 5 grand in the r's. WTF is going on?Has anyone experienced this? Please help!!!!
Thanks,
Koko
Thanks,
Koko
oh man.. this is exactly why I'm still doubtful on going with a CAI... I was looking at the AEM, Injen and Fujita... and for the most part they should work as normal... but at the same time there's problems with Hydrolocking, and also problems just like you described... just random engine malfunctions!
did you clean out the MAF sensor before installing it back into the Injen ??
did you clean out the MAF sensor before installing it back into the Injen ??
Are u letting off the gas when u get to high RPM's??? I know when i had my injen intake on, at high speeds letting off the gas would cause the air to get sucked out of the tube and cause a venturi effect... The air passing through the intake was greater than the air being sucked up from the motor; which sucks the air out of the tube...
Trending Topics
Thanks to all for your responses, 1. I will put the stock back on and see what happens. 2. I didn't take my foot off the gas, it just shuts down. 3. What I don't understand is that a friend of mine bought the same exact one and his car seems to work fine. 4. It works fine as long as i don't floor it above 5 grand. Any other suggestions?
Thanks,
Koko
Thanks,
Koko
Originally Posted by kokor1
Thanks to all for your responses, 1. I will put the stock back on and see what happens. 2. I didn't take my foot off the gas, it just shuts down. 3. What I don't understand is that a friend of mine bought the same exact one and his car seems to work fine. 4. It works fine as long as i don't floor it above 5 grand. Any other suggestions?
Thanks,
Koko
Thanks,
Koko
i say get a new short ram intake like Stillen
Thread
Thread Starter
Forum
Replies
Last Post
Mad A
Not G35 Related
4
Dec 8, 2015 01:45 PM





