Hey guys,

I have been following this: http://www.odometergears.com/subpage...ar_How_To.html

So this is what happened I replaced the gear and put everything back on, then i noticed I forgot to put the bolt back on to hold the gear. So when i dismantled it again, and it took off the motor off the gear it was stuck, i pulled it off and this ring bolt was stuck. I got it off but i looked inside the motor circle, the ring definitely was in it so I took the ring and put it back at the very end of the motor inside.

I put the securing bolt back on the screw gear and made it as tight as possible (I assume this is correct). I tried to slide the motor back on to the gear screw and it wont slide all the way on the screw. I dont know what is wrong and I followed the steps. It doesnt look like anything is blocking it so I cant figure it out.

I know it was just the gear to causing the problems but now I cant fix what I already fixed ...........