airbag llight

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Feb 22, 2008 | 01:36 AM
  #1  
jdmv35_99's Avatar
Thread Starter
|
Registered User
Joined: Feb 2008
Posts: 62
Likes: 0
From: los angeles
airbag llight

my airbag light is blinking and it doesnt stop..what could be the reason??
 
Reply
Old Feb 22, 2008 | 11:34 AM
  #2  
Big Rob's Avatar
Never gone
Staff Alumni
iTrader: (14)
Joined: May 2007
Posts: 8,514
Likes: 21
From: San Jose, CA
Why is this in the Check Out My Wheels section?

I'm sure a Moderator will move this to the proper area, where the OP can get some helpful responses.
 
Reply
Old Feb 24, 2008 | 11:50 PM
  #3  
06g35meister's Avatar
Registered User
iTrader: (8)
Joined: Sep 2007
Posts: 1,914
Likes: 7
From: Waco, TX / Leawood, KS
ttt, mine started blinking after i took my seat out to vacuum hardcore... will resetting the ECU work?
 
Reply
Old Feb 26, 2008 | 11:52 PM
  #4  
xjonmo's Avatar
Registered User
iTrader: (12)
Joined: Nov 2006
Posts: 2,007
Likes: 0
From: New Jersey/Boston
mine started blinking for no reason at all
 
Reply
Old Mar 3, 2008 | 06:09 PM
  #5  
JDM_SKY's Avatar
Registered User
iTrader: (15)
Joined: Apr 2007
Posts: 157
Likes: 0
From: Seattle, WA
same here. just happened today.. anyone knows the answer??
 
Reply
Old Mar 3, 2008 | 06:10 PM
  #6  
06g35meister's Avatar
Registered User
iTrader: (8)
Joined: Sep 2007
Posts: 1,914
Likes: 7
From: Waco, TX / Leawood, KS
make sure the seats are plugged in all the way, but i think we will be forced to have the dealer reset it...
 
Reply
Old Mar 3, 2008 | 06:11 PM
  #7  
06g35meister's Avatar
Registered User
iTrader: (8)
Joined: Sep 2007
Posts: 1,914
Likes: 7
From: Waco, TX / Leawood, KS
for nissans:
How to reset SRS(air bag) light:

Open the driver's door. Note the rubber covered button located low on the B pillar, a button which is pressed by the door when the door is closed. This is the Driver's Door Switch (DDS).

Turn the ignition from OFF to ON. Press the DDS at least 5 times within 7 seconds after turning the ignition switch ON. Turn the ignition OFF. Close the driver's door. Start the engine.

If the airbag warning lamp is still on (or still flashing), there is a fault in the Supplemental Restraint System which must be diagnosed and repaired.
 
Reply
Old Mar 3, 2008 | 06:50 PM
  #8  
06g35meister's Avatar
Registered User
iTrader: (8)
Joined: Sep 2007
Posts: 1,914
Likes: 7
From: Waco, TX / Leawood, KS
had one person report it didnt work, can i get a second for verification??? this one person could actually have a problem, but i want to make sure before i send him to the stealerships.
 
Reply
Old Mar 3, 2008 | 06:57 PM
  #9  
zackt69's Avatar
rarejdm.com
iTrader: (43)
Joined: Sep 2005
Posts: 2,140
Likes: 36
From: Pasadena, Ca
Turn the key to the on position and watch the airbag light. It should stay solid for 5-7 secs, and then turn off, and then start to flash.

To reset the light, you must turn the key to on, watch the airbag light stay solid for 5-7 secs and as soon as the airbag light turns off, turn the key to the off position (you have to turn the key to off before the airbag light starts to flash, or you must start over). You need to repeat this 5 times. Try to start the car, and hopefully the light will be reset.
 
Reply
Old Mar 3, 2008 | 06:57 PM
  #10  
06g35meister's Avatar
Registered User
iTrader: (8)
Joined: Sep 2007
Posts: 1,914
Likes: 7
From: Waco, TX / Leawood, KS
^^ thank you, you rock.
 
Reply
Old Mar 3, 2008 | 07:00 PM
  #11  
zackt69's Avatar
rarejdm.com
iTrader: (43)
Joined: Sep 2005
Posts: 2,140
Likes: 36
From: Pasadena, Ca
I went through this a few times with the after market steering wheel I had for a while, and the first time I disconnected my clock of all things. If the light comes back on, then something is wrong and the car should be taken in... this simply resets and clears the light.
 
Reply
Old Mar 3, 2008 | 07:02 PM
  #12  
rookie's Avatar
Former G35driver Vendor
iTrader: (19)
Joined: Mar 2006
Posts: 3,420
Likes: 5
From: OC
Here's the diagnostic mode from the service manual. It's out of the 05, but I looked in the 03 and it said the same sequence.


Warning lamp examples.


This has worked for me in the past when something was left disconnected.
 
Reply
Old Mar 3, 2008 | 07:05 PM
  #13  
06g35meister's Avatar
Registered User
iTrader: (8)
Joined: Sep 2007
Posts: 1,914
Likes: 7
From: Waco, TX / Leawood, KS
once again, a sucessful fix by the know it all's,. thanks guys!!!
 
Reply
Old Mar 3, 2008 | 07:11 PM
  #14  
jdmv35_99's Avatar
Thread Starter
|
Registered User
Joined: Feb 2008
Posts: 62
Likes: 0
From: los angeles
yes i tried it right now and the light went off..thanks guys....
 
Reply
Old Mar 3, 2008 | 07:13 PM
  #15  
zackt69's Avatar
rarejdm.com
iTrader: (43)
Joined: Sep 2005
Posts: 2,140
Likes: 36
From: Pasadena, Ca
sweet
 
Reply


You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 12:23 AM.