Thanks guys!

Marcus - I'm ready when you are

As for the front fitment, it can definitely come out another 5mm, maybe another 10mm to poke out, but then I wouldn't be able to turn. It already hits fender pretty bad on a full turn going up an incline. But I guess if you're not rubbing, your not low enough, lol. Probably should run a 225/35 if I wanna add some more spacer.

 

^ I just threw some 15 mm spacers on my fronts making them +9 on a 9' wheel. Perfect amt of poke IMO but im running 225/35's.

 

well, this thread more than any other inspired me..

I just ordered my wheels today.. 20x9.5 +14, and 20x10.5 +20



See you guys in 6-8 weeks! Hopefully ill have a few more suprizes to go with it

 

nicee, those are some good offsets. I think +23-25 is the perfect offset for the rear when it is a 10.5 wheel. In terms of camber and fender work

 

Heres my setup, still a work in proress. Will be addin spacers in the fronts and rear, and play with camber.

 

Nice, I wanna see more pictures of your car.

 

i had a 9+4 with a 215/35 and it sat perfect throw on a 20mm youll still be able to run a 225/35.

 

looks crazy!.. what are your specs?

 

If i decide to go lower i will prob throw on the 20mm or 25mm. But at the current height i have the perfect amt of poke cause it matches my rear.

 

I'm running a +35 R and right now + 40 F and was going to order the ichiba V2 with a 10mm spacer on the front to drop it to +30 ... would that be close to an aggressive look or would i need spacers in the rear as well ?? im not looking for a crazy aggressive look but a decent looking set-up .. what more should i do ??

 

Congrats.. i wish i could run those specs but a 245 35 on a 10.5 and running
-3.5 camber was a lil too much for me.

I think i can get some used 20x11 +15 HRE's locally but man that's just too aggressive for me on coils. If i was on bags and really stretched tire i think i could pull it off.

 

Need to know the width of your wheels to help with recommendation.

My recommendation would be to get the height and camber where you want it. Then measure from wheel to where your want the wheel to be. Here is an example of mine.

Old setup. I took a tape measure and meaure where the wheel was at and figured out how far i wanted the wheel to poke out. For my setup i wanted it to come out .5 inches which is 12.7 mm. So i went with 15mm spacer.



And here is the result.


LMK if this doesn't make sense.

 

im running 19x8.5 F +40 w/ 245/35/19 and 19x9.5 +35 R w/ 265/30/19 ... i have 350z tein s-techs in the garage but need to get the fenders rolled .. i tried to get in there today but the place is slammed so im going to try and get in there friday ....

 

^ TycoRC was running the same width but he was at +20 all around and you can see his specs and what he did for them to fit at:
https://g35driver.com/forums/19-inch...lo-wheels.html

 

well i was planning on keeping the rear at +35 and throw on a 10mm spacer for the front to drop it to +30 .. i think that should be a decent setup for now and not to crazy and should look pretty good