dropp is now on the car !!!! pics
#1
dropp is now on the car !!!! pics
as you guys once new me as the snoop 4x4 id like to say here we go i installed the 350z tein s techs and struts on my 06 sedan it dropped a little more then i expected but dammm it looks good the ride is not that bad either and good thing is i dont RUB in the rear just need some spacers for the front and it will be perfect and dont hate on the RED calipers !!!!!
before
and NOW hope you guys enjoy !!! i went from a 4 finger gap on front to none and rear i went from a 3 finger gap with CUT FENDERS NOW to only my G key going in at a angle up ...
if you want different angle pictures LMK ill take a few more snap shots
before
and NOW hope you guys enjoy !!! i went from a 4 finger gap on front to none and rear i went from a 3 finger gap with CUT FENDERS NOW to only my G key going in at a angle up ...
if you want different angle pictures LMK ill take a few more snap shots
Last edited by SN00P; 04-12-2010 at 06:07 PM.
#5
iv searched and searched these forums and iv yet to find some 350z teins s techs on a sedan ... i drove down the road and some guy in a 350z said what kind of coilovers you have lol b4 my drop i was able to put 4 fingers in the back and i measured it to be 3'' and i went lower ???? its at least or more then 3'' drop
Last edited by SN00P; 04-12-2010 at 05:22 PM.
#7
Trending Topics
#8
#12
i did no they where going to drop but when i looked at almost every site they say like .7 .8 or so drop and i added a inch to that thinkin about 2'' right ???? so i get them on and lower it down slow and the gap started get smaller and smaller till i was like dammmmm i went down over 3'' lol but no rubbing at all so its perfect ...
and isschriss 10mm spacer in the back might put my tire in the fender right i dont have a camber kit on the rear so once i fix that i wont need spacer in the rear i dont think and yes i agree with a spacer in the front i was thinking more like 10mm in the front to put me at +30 the rear is +35 and i have a 1/8'' gap from side of tire to fender
and isschriss 10mm spacer in the back might put my tire in the fender right i dont have a camber kit on the rear so once i fix that i wont need spacer in the rear i dont think and yes i agree with a spacer in the front i was thinking more like 10mm in the front to put me at +30 the rear is +35 and i have a 1/8'' gap from side of tire to fender
#13