Jack Stands and the G
#256
Registered User
iTrader: (10)
#257
Registered User
iTrader: (5)
this thread is quite entertaining jus read through it all. I kno this is a very old thread but so the guy made some adapters for jack stands with high "Y" shaped arches that don't even make contact with the pinch welds and sold them for almost $50 a piece?
that's insane, I can see its use if the jack stand was "U" shaped with a very low arch then itll bend the pinch welds. but that doesn't seem to be the case here lol. or am I missing something?. also for $15 u can buy grip floor jack saddle adapters to fit the pinch welds to be used with the floor jack.
that's insane, I can see its use if the jack stand was "U" shaped with a very low arch then itll bend the pinch welds. but that doesn't seem to be the case here lol. or am I missing something?. also for $15 u can buy grip floor jack saddle adapters to fit the pinch welds to be used with the floor jack.
#261
Well that was to lift the car. My stands are almost flat and I put them on a flat piece close to center and didn't see any issues. Its just a tad lower than usual.. I'm def gonna get a lower profile jack though.
Thread
Thread Starter
Forum
Replies
Last Post
Hogbone
Engine, Drivetrain & Forced-Induction
2
09-28-2015 06:44 PM