Hypertech Programmer for 03/04 sedans?
#16
03basesedan is correct,
Sorry man, I went to Denver on the 9th and left my virus infected laptop at home to work Jeep fest/show for Four Wheel Parts and returned yesterday. I spoke with engineering this morning and the software issue is being worked out. Sorry for the delay and hold up in engineering.
Please call me if you have any questions.
Jay 800-532-3351 ext.1435
Sorry man, I went to Denver on the 9th and left my virus infected laptop at home to work Jeep fest/show for Four Wheel Parts and returned yesterday. I spoke with engineering this morning and the software issue is being worked out. Sorry for the delay and hold up in engineering.
Please call me if you have any questions.
Jay 800-532-3351 ext.1435
#17
Registered User
iTrader: (8)
Join Date: May 2007
Location: Northeast
Posts: 669
Likes: 0
Received 0 Likes
on
0 Posts
03basesedan is correct,
Sorry man, I went to Denver on the 9th and left my virus infected laptop at home to work Jeep fest/show for Four Wheel Parts and returned yesterday. I spoke with engineering this morning and the software issue is being worked out. Sorry for the delay and hold up in engineering.
Please call me if you have any questions.
Jay 800-532-3351 ext.1435
Sorry man, I went to Denver on the 9th and left my virus infected laptop at home to work Jeep fest/show for Four Wheel Parts and returned yesterday. I spoke with engineering this morning and the software issue is being worked out. Sorry for the delay and hold up in engineering.
Please call me if you have any questions.
Jay 800-532-3351 ext.1435
Thanks for getting back to me/the forum. I'll be sure to pester you guys until you get that update out! Keep us posted!
#19
Registered User
iTrader: (8)
Join Date: May 2007
Location: Northeast
Posts: 669
Likes: 0
Received 0 Likes
on
0 Posts
Jay needs to email me back.
We spoke on the phone a couple of times, and a week or two ago I know they bought a G35 to work on. Otherwise, details have been few. If this doesn't work sometime soon, I'm going to sell it. I'll be in the DC area this fall, and I'll just stop by AAM for a proper dyno tune.
We spoke on the phone a couple of times, and a week or two ago I know they bought a G35 to work on. Otherwise, details have been few. If this doesn't work sometime soon, I'm going to sell it. I'll be in the DC area this fall, and I'll just stop by AAM for a proper dyno tune.
#22
It all starts the same, but when they realize that the Early 2003s have a different ECU (different code altogether) then they "forget" that they were going to support us.
#23
Registered User
iTrader: (8)
Join Date: May 2007
Location: Northeast
Posts: 669
Likes: 0
Received 0 Likes
on
0 Posts
I sent some info about the upload error to Hypertech today. They loaded a special "diagnostic" update onto my unit, and it spit out a couple of parameters. The error code has been forwarded to the techs, and hopefully I will know more soon.
Thread
Thread Starter
Forum
Replies
Last Post