All I want to know is will a 19/10.5 +25 fit on the g35 sedan and sit under the fender

 

Its will depending on tires. Im on 255s on a 10.5 with +25. U wanna roll your fenders if ur going low.

 

I should be fine with any of these setups right? Also would like your opinions on which ones i should go with..


1.) CE28N Time attacks white/red stripe 19 x 9.5 +22 all around

2.) TE37SL diamond black F:18x10 +20 R:18x11 +18

3.) SSR typef greyish 18x9.5 +22 all around

DG coupe, thanks in advanced!

 

Te37sl.

 

Probably everyones answer =p I do like them the most too theyre just priceyy

 

i have 2004 Infiniti g35 Coupe with Brembo breaks
i need some help purchasing the rims
i want to get 20" WORK VS-XX
front 20 X9.5
rear 20 X 10.5

i need to know the offset any suggestion

 

Buy Chris' setup (jdmcain on here )

 

O5 coupe AT I have 18x9 rims with a +35 offset. I can't figure out what my spacer limits would be, can anyone help me out it would be very much appreciated!!!

 

Well what are you lookiNg for. Flush fitment?

 

you can throw up to 45mm in the front and up to 60MM in the rear.

assuming you're running a slight stretch, and have rolled fenders.

 

I do not have my fenders rolled and I'm looking for a flush to maybe a half inch out.. Anyone have any advice on what sizes I should get for my front and back?

 

Will there be any scrapping / rubbing issues? I have an 04 coupe. I only want to lower it half and inch to an inch.

 

Not enough information.

It also depends on your wheel offset. If you're at about +20ish or higher you should be fine. Anything lower you'll need a fender roll and possibly a pull too. You can avoid this if you run more negative camber.

 

I don't know the offset. I bought it used from the dealer. It's an 04 coupe on 20" fx35 rims.

 

Google fx35 offset. It should be +45 or so...which is very conservative. Plus I think the width is around 8.5 or 9. You will need spacers to avoid it from looking sunken in.