Have a Question/s About Wheels/Tires/Offsets/Camber/Etc? Ask here::
Im adjusting it to half an inch lower tomorrow. Not stechs my bad but tein street basis coilovers. hopefully with that and some negative camber i can get rid of a good amount of poke in the rear.
Me thinks I need more camber..... So or spc, spl, or stance arms? I'm running 245 and 275 I believe. By 35 on both I thinks that's the tire number. Last owner ran -4 camber up front -5 rears. I need some help on fitment. Will I need to sell my 275's and go to 255 tires on the rear? Can I make my 275's work? Im debating running semi aggressive camber until these tires are shot then straightening them out a little bit later. My possibility 2 is widening out my rear end. Im just un sure on what to do. I am rolled flat and slightly pulled in the rears. I may have to pull more.
Specs are
19x10 -5 front
19x11 - 10 rears.


Specs are
19x10 -5 front
19x11 - 10 rears.


I saw the pic of the previous owners car. What tire sizes where they running? I would get the same tire sizes, set the camber -4 and -5 degrees, drop it and then pull to fit. Done!
Ya you and me have chatted about sizes before. I think he was on 255. I just dont feel like dropping about 1000 more into the suspension setup. Dunno though. I may. Just wish my 275 would work.





