Have a Question/s About Wheels/Tires/Offsets/Camber/Etc? Ask here::
#1066
question
Here is my new wheel setup, and I am having a tough time finding tires that will best fit this.
04 g35 coupe
My car is slammed on full coils, exhaust hits on speedbumps etc.
19x8.5 +15 19x10.5 +20
I got 235/35/19's for dirt cheap like 90% tread so I would like to use them but dont have to. These will work fine correct? Little stretch probably look good with the offset?
I was trying to find 275/35/19's used, but cant find any cheap....so now im thinking of going 265/35/19's..and my question is will this work? Am I even on track with the right tire sizes? Opinions please. Thanks
04 g35 coupe
My car is slammed on full coils, exhaust hits on speedbumps etc.
19x8.5 +15 19x10.5 +20
I got 235/35/19's for dirt cheap like 90% tread so I would like to use them but dont have to. These will work fine correct? Little stretch probably look good with the offset?
I was trying to find 275/35/19's used, but cant find any cheap....so now im thinking of going 265/35/19's..and my question is will this work? Am I even on track with the right tire sizes? Opinions please. Thanks
#1067
#1072
I was thinking about getting a set of work vs-fx (19x9.5 front/19x10.5 rear) for my 06 coupe. What disk/offset would you guys recommend? Currently I have stoptech bbk (6piston front/4piston rear) and lowered on tein s-tech springs.
http://www.workwheelsusa.com/media/w...3/VSFX_PDF.pdf
http://www.workwheelsusa.com/media/w...3/VSFX_PDF.pdf
Last edited by gsracerx98; 07-22-2010 at 03:22 AM.
#1074
20x8.5 +5 (w/ 15mm spacers)
20x10 +10 (w/ 15mm spacers)
Normally, on an 8.5 wheel, you'd run a 245 size tire. For the front, 225/35 would clear. Its not a 9.5 wide wheel so you'll have some clearance from the fender.
As for the rear, a 245 / 35 stretch or a 255 / 35 stretch would be fine in order to clear.
Dial in a bit of negative camber and you should be ready to roll.
#1075
I was thinking about getting a set of work vs-fx (19x9.5 front/19x10.5 rear) for my 06 coupe. What disk/offset would you guys recommend? Currently I have stoptech bbk (6piston front/4piston rear) and lowered on tein s-tech springs.
http://www.workwheelsusa.com/media/w...3/VSFX_PDF.pdf
http://www.workwheelsusa.com/media/w...3/VSFX_PDF.pdf
O-disk rear
the drop on S-techs are not that much so unless your staying with that or getting coils and lowering the car in the future
i suggest getting conservative offsets probably +12 Fr +17Rr?
I finally got my wheels back from chroming the barrels. They are Volk GT-S 19x9.5 +2 (15mm spacer) 235/35/19 & 19x10.5 +3 (15mm spacer) 255/35/19 (Toyo T1R) . Im on Tein Flex and the rears are maxed out. I need another 1/2" - 3/4" lower. Should I cut the spring mount?? Suggestions?
#1077