FS: Vortech supercharger for revup
#16
i been really busy with school, sorry for not getting back to you guys. my car is going into shop for twin turbo install soon.. just waiting for shop to have space for my car. Once the kit is off the car pics will be posted shortly.
#19
I wouldnt consider this a broken kit...Bearings go bad, mine just did after 35K of drift miles..whats cool about the rev-up set up is that you can drive the car without the blower in it. Although if you punch it you will flood the cylinders with gas without boost...but normal driving is fine.
I am sending mine off this week for a repack and once over....if you buy any used kit you should save yourself the time and send it to vortech for a 3-400 once over...saves time and money in the long run.
GLWS. If it was a T-Trim Id get it from you.
I am sending mine off this week for a repack and once over....if you buy any used kit you should save yourself the time and send it to vortech for a 3-400 once over...saves time and money in the long run.
GLWS. If it was a T-Trim Id get it from you.
#21
T Trim Blower default PSI is close to 12 I think....
so stock block + T Trim = Blown Motor....lol
It can push 26-28PSI...its the same blower that is the upgrade for the Mustang Cobras... and big blocks....its no freggin joke.
so stock block + T Trim = Blown Motor....lol
It can push 26-28PSI...its the same blower that is the upgrade for the Mustang Cobras... and big blocks....its no freggin joke.
Thread
Thread Starter
Forum
Replies
Last Post
alxmlr789
20 Inch
9
01-26-2016 10:04 AM
FreshVQ
The G-Spot
4
09-30-2015 01:41 PM
n2fooz
Engine, Drivetrain & Forced-Induction
0
09-04-2015 07:46 PM