Replaced head unit still no sound
#1
Replaced head unit still no sound
Installed a Pyle PLDNV78i using the pac and using Wrathernaut's instructions and I have no sound. Stereo powers on and memory works. I checked for power at the amp and that's good. How do I make sure the pac is working and is there a way to check that sounds is getting to the speakers? Thanks
#2
#3
#5
#6
#7
Just check for a low-voltage A/C signal on the speaker wires to check for signal.
Trending Topics
#8
Where would be the best place to check? This is a stupid problem to have. I'm seriously considering replacing all the speakers and by passing the amp. Then eventually adding a sub.
#10
Thread
Thread Starter
Forum
Replies
Last Post