SPC NOT Working
#1
SPC NOT Working
I just had KW V2 installed and not lowered too much (about 1 finger gap) and then had SPC rear camber/toe kit installed by Dallas Frame & Alignment. These guys are really good and many of the Supra guys swear by them. They do everything by hand and work on everything from race cars to 18-wheelers. Even with the SPC rear camber/toe kit installed, they could only get it to -1.75 in the rear. This is with my factory 18" wheels and tires, and I know once my 10.5 +15mm wheels are on, the camber will be even more negative.
What do you think is causing this issue? Could the camber/toe kit have not been installed properly?
Would installing a front camber kit make any difference to the way the back sits?
Any help would be appreciated. Thanks.
What do you think is causing this issue? Could the camber/toe kit have not been installed properly?
Would installing a front camber kit make any difference to the way the back sits?
Any help would be appreciated. Thanks.
#2
changing the front will do nothing to the rears.
I have the same problem with the SPC rear kit. I can only get -1.7 and -1.8. make sure your toe bolts are installed in the correct place. they do not go with the camber arms. they go on the body side where the spring bucket is.
also when they installed the camber arms, they should have threaded each side of the arm into the adjuster equally to match the stock length.
did you roll your fenders? i think 10.5+15 will rub badly with your drop.
I have the same problem with the SPC rear kit. I can only get -1.7 and -1.8. make sure your toe bolts are installed in the correct place. they do not go with the camber arms. they go on the body side where the spring bucket is.
also when they installed the camber arms, they should have threaded each side of the arm into the adjuster equally to match the stock length.
did you roll your fenders? i think 10.5+15 will rub badly with your drop.
#4
#6
#7
Trending Topics
#11