im ready to lower my car a bit...
planning to get Z's Htech
says that
"Tein H-tech 350z linear springs .3”/.2” drop on 350Z G35 drop will be higher
Spring rates in LBS 358/375 "

so those on G coupe gives a .5 more drop right??
so its .8 front n .7 back...
with that i dont need a camber kit right???

but when it settles down...will it go lower than 1inch???then will i need camber kit?

 

- yes, they'll lower the coupe just under an inch.
- some people think the drop is uneven so they cut the rear springmounts down a little (search spring mount mod).
- you should get at least a rear camber / toe kit. you can get them for as little as $170 new and it will be cheaper if you install them at the same time as the springs.

 

I dont get the UNeven part???
which uneven...??
Left n Right??

 

front vs. rear

 

i dont get it...
shouldnt the front lower than rear???

 

if you search around on this topic, you'll note most people end up with the rear sitting noticeably higher than the front. the solution is to cut down the rear spring mounts - again, search for 'spring mount mod'

 

aite aite
thanks fo the heads up...