problem with kinetix v4 plenum
#1
problem with kinetix v4 plenum
Hi. i just installed the kinetix v4 plenum and test drove the car. car cranked up fine like stock and i took it for a wild spin to test it out. came back home and told my friend to test it out hours later... cranked the car, rpm fell down to 0 and the car stalled. cranked again, same deal... so i cranked it with some gas and the car fell to a very smooth idle. turned it off and cranked it again with a long start and the car fell to a very smooth idle. i then proceeded to drive the car for 30 minutes and turned off the car in attempt to see if the car will crank up normally... but it doesn't!
anyone have a clue what i am talking about? idles and rpms are very smooth and nominal though.. no bogging while riding! only during crank/ignition... seems like car is not getting enough combustion to start?
anyone have a clue what i am talking about? idles and rpms are very smooth and nominal though.. no bogging while riding! only during crank/ignition... seems like car is not getting enough combustion to start?
#2
#3
thanks for the reply!
only happens during hot-cranks... during cold-cranks the car ignites with ease at a higher idle. yes i THINK i noticed a bit more power at top end.
i apply the gas only when the revs start to drop to induce a stall. need more air to keep the engine alive.
i guess i shall disassemble the plenum and parts tomorrow... get everything thoroughly checked... we'll see what the culprit was.
only happens during hot-cranks... during cold-cranks the car ignites with ease at a higher idle. yes i THINK i noticed a bit more power at top end.
i apply the gas only when the revs start to drop to induce a stall. need more air to keep the engine alive.
i guess i shall disassemble the plenum and parts tomorrow... get everything thoroughly checked... we'll see what the culprit was.
Thread
Thread Starter
Forum
Replies
Last Post
G35_TX
Engine, Drivetrain & Forced-Induction
59
07-08-2004 03:24 AM