Slip/VDC OFF, then RAS. After Suspension Install
Thread Starter
|
Registered User
Joined: Nov 2017
Posts: 14
Likes: 0
Slip/VDC OFF, then RAS. After Suspension Install
2006 G35 Coupe
I know! just couldn't find one like this, I checked the obvious fluid levels and other recommended. No codes.
Just did a suspension refresh and now I'm throwing Slip/VDC OFF once i hit 25-30 MPH, then RAS joins them after a minute or two of driving. Light all turn off when car is turned off and restarted, then after the 25-30MPH and few min of driving, all lights back on.
Just replaced
- Wheel Bearings
- Control Arms
- Ball Joints
- Tie Rod ends
- Swap Bar End-links
- Sway Bar Bushings
Did not disconnect battery, may have stressed the sensor that bolts to the hub as the knuckle fell forward and was caught by the sensor and the ball joint. Any thoughts are appreciated!
Thank you!
I know! just couldn't find one like this, I checked the obvious fluid levels and other recommended. No codes.
Just did a suspension refresh and now I'm throwing Slip/VDC OFF once i hit 25-30 MPH, then RAS joins them after a minute or two of driving. Light all turn off when car is turned off and restarted, then after the 25-30MPH and few min of driving, all lights back on.
Just replaced
- Wheel Bearings
- Control Arms
- Ball Joints
- Tie Rod ends
- Swap Bar End-links
- Sway Bar Bushings
Did not disconnect battery, may have stressed the sensor that bolts to the hub as the knuckle fell forward and was caught by the sensor and the ball joint. Any thoughts are appreciated!
Thank you!
Last edited by G35stephen; Jun 13, 2019 at 09:03 AM.
Thread Starter
|
Registered User
Joined: Nov 2017
Posts: 14
Likes: 0
I sure did this morning! I was just making sure before I posted but the lights have went away since the alignment! Thank you!
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods
I was confused because he said the lights went away after the alignment but the problem was fixed by replacing a cam sensor. Hence the 
Trending Topics
I was confused because he said the lights went away after the alignment but the problem was fixed by replacing a cam sensor. Hence the
Thread
Thread Starter
Forum
Replies
Last Post
G35stephen
Brakes & Suspension
2
Jun 12, 2019 09:34 PM