^ there are non, you need to buy the outer case, eBay has em cheap

^ Good call, found one for $17.. Thanks

Will spacers help me clear akebono bbk? I have oem 18" rays look a likes. The specs are 18x7.5 +45. Any help is appreciated.

can i put an OEM HID harness in my fogs so they are uniform? if so how?

Ordering spacers today or tomorrow, need help deciding between 10 & 15mm. My setup is 20x8.5 +40 on 245/35/20 on all four. Lowered on Eibach Pro - I asked once before and got one opinion: 15mm - I would really like to see a lowered sedan on 8.5" with a 25mm or 30mm offset.

Anyone have an answer for me?

You can run an HID ballast for your fogs but it's not OEM. Many have done it.

Thanks I have 6000k in my headlights but I want it ti match if I use the same bulbs and after market ballast think it'll match?

8.5 +33mm is any REAR 350z wheel/g35 coupe. So the 19's ray coupe that everyone and their momma has. Its half of what you want.

A few of our members are using 3000K HID fogs and they seem to like the combination. Matches 6000K headlights. Poke through the lighting section for more info. I went with yellow fogs and really like them.

Do you guys think these could fit on a sedan bumper without much work?

http://www.dashzracing.com/Lighting-...-p9405588.html

What parts do I need for a projector retro fit? What will the total cost be?. I want to COPY Marcus's design.

^Below are prices I've seen available right now. Projectors are subject to price change depending on availability
$199 - for a set of g35/g37 projectors w/ballasts, bulbs and ignitors (good deal!)
$55 - clear lenses for projectors
$40 - LEDs strips/rings...etc
$10 - spray paint...more if you have bezels professinally painted
$15 - miscallaneous bolts, screws, nuts, washers and some epoxy
$100,000 - labor costs to do them...I'm a government employee so this cost is drastically inflated

I think that covers it...I could be missing something.

Oh...the deal on the projectors can be found here

http://cgi.ebay.com/ebaymotors/hid-x...Q5fAccessories

I purchased busted up g35 2nd gen sedan headlights which came out to a little more than this. Take a look on ebay and compare the prices and you will see this is a good price

No. I've had a set of coupe ducts and held them up against the sedan nismo, they're not even close.
Besides that, why would you want to? Those look tacky.