bump bump. bump.

i may start this today myself. passenger side and driver side.

i don't think kenny covered the driver side, or maybe i scrolled through the thread too fast and missed it.

Anything on that big wire loom in the center?

 

Lable, take pics. Unplug everything, deloom, kinds plug **** back once u have a general idea starts electrical taping it back. Once all relommed connect n w fingers crossed wahlah.

 

the coupe driver side loom will not extend to fit the headlight...i have tried both the holes going into the fender. i would try the hole in the bottom because the one right behind the pump is a pain to fit through. i dont even think this is worth it after all i have been doing. what wires do we need to extend for the headlight?

 

Nice DIY.

 

Gmotion: u need to take the plug on the headlight off it is hel by a clip or u can be like me n just break the clip off ether way works. Also it might still not reach after taking the plug off the clip, go back to the loom under the brake fluid tank n try o deloom more. It is worth it at end.

 

im stuck on this stupid driverside harness damn headlight clip is 6 or 7 inches short to be replugged in any suggestions? im thinking about just cutting the area in front of the avs assembly like kennymo did?

 

Has anyone done this to a M yet, My bay is so huge and cluttered the eff up it needs to be a bit organized.

 

Drilling a hole in the wheel well would give you the most room. I just ran the wires through the hole along the fender well but it's a tight fit and just reaches the headlight harness

 

I just extended the headlight wires soldered them together and shrink wrapped the exposed work! Vwala everything worx great! Only issue I had was with the alt wire cuz my 06 did not have a square hole for the alternator wire to go thru and I didnt want to drill so I said f it!!

 

gonna be tackling this job over the winter... may begin tomorrow.
hope i get lucky and everything reaches :P

great DIY by the way

 

not wire tucking the G35, but relocating Nissan's lovely placement of the driver side harness on an S14. It used to run where the tire tread is now.

 

Thank you!!

 

Did anybody ever find a complete diy on the main wire harness? I've searched up and down and nothing at all. Can anyone point me in the right direction

 

Just added this to my to do list of things to do. I've been telling myself I don't need a clean engine bay, but I've decided otherwise..... New bolts everywhere, and basically polishing everything.....

 

The guys with lowered SC300s have to do this. All u need is some wire cutter, zipties and time. Not that hard.