Anyone know If the Arc can clear a 5/16 spacer, mrev2, and 350 z engine cover/or no engine cover w/out rubbing or pushing the hood up?

 

yes it will fit

 

Are there any major modifications that have to be done when installing a strut bar and brace on a G--since out cars do not have struts stock? (any cutting or drilling required?) Is it possible to later take out the arc strut bar and have everything look the same pre-install (or does installation of the strut bar and frame cause permanent indication of install)?

 

no modifications necessary. a simple DIY, just make sure you have the right tools and socket extension. you use stock nuts for the mounting plate. check out richie's front strut bar. it's an aluminum arc replica. they have instructions also.

 

My Richie one clears that same setup.

 

^^Wow TTrank your engine bay is hot!^^ Were you able to use the bolts and fasteners that came on the stock engine cover on the z style engine cover, or did you have to order seperate ones?

 

Will this same setup still work with tien flex's and EDFC?

 

anyone? kuz im looking to get this setup with the ARC bar and tein's but i have heard that it wont clear with coilovers and the EDFC. advice pls

 

It'll work with the EDFC - you just have to disconnect the wire harness, install the plate then put the wire harness back.