When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a 2003 G35 coupe with serious window issues Ive basically done everything possible to trouble shoot these issues! Both window motors are good are Ive done the reset procedures multiple times. anything would help me, ive been stuck not able to drive the windows are stuck in the down position and due to the rapid weather changes here in FLORIDA where one second its sunny then starts Pouring im unable to drive places in fear of getting caught in the rain Thanks in advance!!! Here is my G35 coupe!!
Nothing happens when you push the buttons, the passenger one works until the window goes all the way down. then it doesn't work we have changed the locks and window motor still not working have tried to reset them and still nothing.
Take off the door panel, the inner panel, unplug the harness from the window motor. Use a digital multimeter and read voltage across the two pins of the harness, up should be +12v dc, down should reverse polarity to -12v dc.
If you have voltage then you probably have bad motors (check both doors, you might have a broken wire in one of them at the hinge), if you DONT have voltage then you might have a bad switch, broken wires, bad BCM, etc.
Also, you can roll the windows UP and DOWN by putting hte key in the door lock and holding it to the locked position (up) or unlocked position (down). I think this can be done to bypass the door switch which would help troubleshoot if it has failed.
Also, you can roll the windows UP and DOWN by putting hte key in the door lock and holding it to the locked position (up) or unlocked position (down). I think this can be done to bypass the door switch which would help troubleshoot if it has failed.
I'm not totally sure if the signal comes back from the BCM through the driver window switch though, it's the master switch but I THINK all the power signals are straight from the BCM to the window motors.