subscribed waiting for Blain to post up some pics

 

What kind of offset would I need to run with a 20x10 at a ~2.5 camber in the rear with a 245 or 255 without pulling the fenders but rolled?

 

Probably somewhere in the low +30s with a 245. Brand of tire and how flat your roll is will make that number vary a bit.

 

So what kind of camber with a 245 rolled flat with a +25? About -4?

Also what about a 20x9 +20 or +40 all the way around? Camber in front is ~0.5-~1.0 and stay with a 245 all around?

 

That sounds about right. I would probably just do a slight pull so you didn't have to run as much camber. If you did a 5mm pull you could run ~-3.5 degrees of camber.

Do you want to do a non-staggered setup because you have an X?

 

Just finished taking the wheels a part, dropping the faces off to my metal guy this week if I find time!

I'll take some photos tonight as I am going to go clean the faces and polish the hardware.

 

No. 2 reasons. 1 bc the rims I want don't have the best of specs and 2 so I can rotate

 

Rotating wheels is something that should not be heard in this thread.

And that means you need to look for better wheels!

 

+1, unless you are doing a 10" width all around I wouldn't recommend running a non-staggered setup. A 9" wheel isn't wide enough for the rear, you're gonna be stuck running skinny tires to get any stretch on it.

What wheels are you considering?

 

possibly axis angle.. haven't seen them done before on a sedan..

they have 3 widths 8,9,10

8 is +35
9 is +20/40
10 is +25

 

so i decided im going to keep my 19s and the money i was going to use put it towards my BBK's i want but im still going to stretch my 8.5 and 9.5 tho with either 215/35 or 225/35 and for the rear 225/35 or 235/35 ... im looking to aim the fronts around +10 and rears about +15 ...so im going to keep doing my research :-)

 

Run 10s square

Chris, I'll talk to you when I get back from the gym tonight.

 

^^ ok

 

Chris, for sure don't do a 215/35, trust me! Blain is going to tell you the same thing. To pull off that tire size you have to be absolutely dumped and I know you wouldn't want to go that low.