Wrathernaut's Double-Din Installation FAQ, Shopping and Resource List
#663
Registered User
iTrader: (15)
thanks! appreciate it.
you said: 2) The blue/white and blue (one's antenna amp, the other is the bose amp turn-on signal, I forget which is which) from the ROEM connect to the "system control".
just to clarify: the blue wire with the white stripe and connector from the pioneer wire harness connects to BOTH the blue wire and the blue wire with the white stripe on the ROEM? so, i need to remove the connector? pic of the wire from the pioneer harness is attached.
Thanks.
you said: 2) The blue/white and blue (one's antenna amp, the other is the bose amp turn-on signal, I forget which is which) from the ROEM connect to the "system control".
just to clarify: the blue wire with the white stripe and connector from the pioneer wire harness connects to BOTH the blue wire and the blue wire with the white stripe on the ROEM? so, i need to remove the connector? pic of the wire from the pioneer harness is attached.
Thanks.
#664
There's a high-level input positive and low-level input positive for each of the four channels. The four grounds ( - ) get used regardless of which input level you use. The other positive signal wires won't be used.
#666
http://www.ls1gto.com/forums/showthr...t=#post6934872
http://www.preludeonline.com/f31/diy...-relay-253472/
#667
Everything looks correct except the blue wires. The antenna amp requires more power than aftermarket radios provide on the signal wire. You will get very poor FM reception if you try that. Instead, connect the "power antenna" wire to the red main power wire, or you can use the cigarette lighter's power wire.
#672
Just did the same install a couple weeks back...best way to get it all to fit is to feed the bypass and PAC, and all your "bulk wire" down behind the little bracket/in the left corner (if you're looking at it from your drivers seat) I fit all mine, plus the extra stuff for NAV and bluetooth, etc.
![Biggthumpup](https://g35driver.com/forums/images/smilies/biggthumpup.gif)