Any one replace their lower ball joints?
#211
#213
These are the ones I ordered. I wouldn't recommend getting these because, as you can see in the photo, the rubber boot also covers what I call the pressing flange, which is the part you put the force on to press the ball joint into the control arm or hub, whatever it's called in our cars. I was very afraid that I was going to tear this and all the grease come out so I was extra careful when pressing it in.
The good thing about these though is that they come with a 1 year warranty.
http://www.ebay.com/itm/290908988293...84.m1439.l2649
The good thing about these though is that they come with a 1 year warranty.
http://www.ebay.com/itm/290908988293...84.m1439.l2649
#214
#215
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,299
Received 1,486 Likes
on
1,221 Posts
G35 sedan w/ too much money in mods
The roll center adjusters Megan sells are the replacements for the lower ball joints. They are just designed differently so the return the steering angle to the correct position on lowered cars. If you aren't dropped, these are overkill since they're over $200/pair.
FWIW I'm having mine installed tomorrow, yeah!!
FWIW I'm having mine installed tomorrow, yeah!!
#216
#218
Registered User
iTrader: (3)
I replaced mine with the megans, im lowered. having an issue with right side, the nut that connects the balljoint to the lower control arm continues to come loose. This is causing the nut to tear into the lower control arm. Not sure if there is a problem with the balljoint seat. Anyone else having an issue?
#219
#220
Not sure if I really like the metal ring clips that hold on the boots.. It just looks cheap.. thoughts?
Has anyone used the CZP ball joints?
#221
I ordered two Deeza from RockAuto and should be here tomorrow hopefully. I'll let you know my thoughts on them.
#222
#223
So I just pressed on one of the Deeza ball joints. The Deeza is not flexible at all like the OEM ones.
I used a 22 mm socket, ratchet, 22 in breaker, and the press from advance auto. Took about 5 minutes to do.
Does anyone know if any of the other ball joints are as movable as OEM?
Oh yea Deeza nut is larger than OEM had to use 15/16 to get it on 22/23 mm was to small.
I used a 22 mm socket, ratchet, 22 in breaker, and the press from advance auto. Took about 5 minutes to do.
Does anyone know if any of the other ball joints are as movable as OEM?
Oh yea Deeza nut is larger than OEM had to use 15/16 to get it on 22/23 mm was to small.
Last edited by coffeysm; 11-03-2013 at 09:57 PM.