loud whining noise from engine HELP!
Thread Starter
|
Registered User
Joined: Aug 2017
Posts: 8
Likes: 0
loud whining noise from engine HELP!
Ive had my G35 6mt stored away for about 3 months , i had my plenum off because i was polishing it. i put everything back together , all the bolts are tight, put the battery back in, go to start it , it starts but right away it makes a really loud whining noise from the engine and suddenly dies couple seconds later, i need help
BANNED!!!
Joined: May 2017
Posts: 14,837
Likes: 2,497
From: Washington State
Coupe 6MT Premium RAS
Is a belt squealing? Do you have a video of the sound?
Was the plenum off for the entire 3 months and was the opening adequately protected? You might have a critter in the engine that is squealing?
Was the plenum off for the entire 3 months and was the opening adequately protected? You might have a critter in the engine that is squealing?
Thread Starter
|
Registered User
Joined: Aug 2017
Posts: 8
Likes: 0
I do have a video of me inside the car starting it, not sure how i’d post it here though, the plenum was off roughly for 1 month, in an in closed garage. i’m not sure if it’s a belt because i’m unable to go up to the engine bay to hear exactly where it’s coming from because it will not idle, it dies if i don’t give it a little gas. i’m going to have my friend hold rpm so i can hear where it’s coming from. it doesn’t really sound like a belt, it’s very loud, almost need ear plugs.
Registered User
Joined: Dec 2014
Posts: 1,000
Likes: 116
Sounds like a belt or a pulley. Funny thing is the exact thing happened to me yesterday. Loud noise while driving and then POP BANG. Idler pulley left me stranded for three hrs on the side of the road. Check your pulleys and belts
BANNED!!!
Joined: May 2017
Posts: 14,837
Likes: 2,497
From: Washington State
Coupe 6MT Premium RAS
If it won't idle at all I'd doublecheck the manifold gasket, you may have pinched the oil fill neck (very common mistake) and have a massive vacuum leak. Since the belts are easy to remove you can just take them off and spin all the accessory pulleys (and tensioners) by hand, if one has a bearing problem it will be unmistakable when turning it by hand.
Post video's to youtube and put the link here it will embed the video automatically.
Post video's to youtube and put the link here it will embed the video automatically.
Thread Starter
|
Registered User
Joined: Aug 2017
Posts: 8
Likes: 0
Solved
Ive had my G35 6mt stored away for about 3 months , i had my plenum off because i was polishing it. i put everything back together , all the bolts are tight, put the battery back in, go to start it , it starts but right away it makes a really loud whining noise from the engine and suddenly dies couple seconds later, i need help
well, i found my problem, my plenum was pinching my oil fill rubber neck thing, it was causing a vacuum leak! i took off plenum, got the rubber piece out of it, bolted it back, started and ran like a charm!
BANNED!!!
Joined: May 2017
Posts: 14,837
Likes: 2,497
From: Washington State
Coupe 6MT Premium RAS
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
theoneyouwant
Brakes & Suspension
4
Feb 9, 2013 12:17 AM
Igor911
Engine, Drivetrain & Forced-Induction
26
Feb 16, 2011 12:53 PM
nubi4life
G35 Coupe V35 2003 - 07
4
Aug 16, 2010 11:12 PM
mca00176
Engine, Drivetrain & Forced-Induction
15
Mar 22, 2008 06:15 PM
