Forced Induction Discussion of turbos , superchargers , and nitrous upgrades on the G35

Forged Performance: rcdash's twin turbo G35

Thread Tools
 
Search this Thread
 
Rate Thread
 
  #136  
Old 04-17-2009, 10:56 PM
tiguy99's Avatar
Registered User
iTrader: (2)
Join Date: Feb 2007
Location: Chicago
Posts: 4,315
Received 30 Likes on 25 Posts
Boggess, lets say you leave the car in D mode, and from a dig, you feather the gas pedal...does it still try to race to redline before it shifts out of first to 2nd and so on?

Or does the trans act the way you described when you floor the pedal?
 
  #137  
Old 04-18-2009, 01:11 AM
Boggess's Avatar
Registered User
Join Date: Dec 2006
Posts: 15
Likes: 0
Received 0 Likes on 0 Posts
tiguy99, Thanks for the comment. I just took it for a spin to check this out. In D mode, with the VDC off, feathering the pedal pretty much jerks the car around a bit, and the rear wheels eventually break loose. The tranny doesn't seem to slip at all.

I know I have a traction issue, but even when I get a good launch, there is still a coordination issue between 1st and 2nd gear. To answer your question, it seems to occur when I floor the pedal.
 
  #138  
Old 04-18-2009, 01:38 AM
tiguy99's Avatar
Registered User
iTrader: (2)
Join Date: Feb 2007
Location: Chicago
Posts: 4,315
Received 30 Likes on 25 Posts
No prob bro...I have the perfect solution! Ever tried 295/30/19 on the rear tires (assuming you have 19s thhat can support wide rubber)

http://www.tiredeals4less.com/TOYO_P...100W_P1984.cfm

It may help
 

Last edited by tiguy99; 04-18-2009 at 01:42 AM.
  #139  
Old 04-18-2009, 05:33 AM
Canadian's Avatar
Canada, eh?

iTrader: (21)
Join Date: Oct 2005
Location: Las Vegas, NV
Posts: 4,275
Likes: 0
Received 13 Likes on 10 Posts
Def get some stickier tires if you haven't already. I just ran some 295/35/18 Nitto NT05's and they pretty much solved my traction issues in 1st gear. They also rocked on the track.
 
  #140  
Old 04-19-2009, 10:24 AM
Boggess's Avatar
Registered User
Join Date: Dec 2006
Posts: 15
Likes: 0
Received 0 Likes on 0 Posts
Thanks fellas, yeah I definatley need sticker & wider tires. I am running Nitto NT555's 275/30R/20. The tread rating is 300, so not sticky at all. I just had my fenders rolled so I can put larger rubber on.

However, I still think my tranny has an issue. Canadian, does your tranny ever hit the rev-limiter and miss 2nd gear?
 
  #141  
Old 04-19-2009, 01:25 PM
rcdash's Avatar
Registered User
Thread Starter
iTrader: (4)
Join Date: Oct 2004
Location: NC
Posts: 2,173
Received 32 Likes on 26 Posts
Originally Posted by tiguy99
Mmm tasty! I will be in Austell in a few weeks Worst case, I may have to make an offer 5.00 higher

j/k

Congrats on everything. Your 5AT G is actually one of my inspirations. Lets me know I too can play with the big boys no matter what any 6MTer has to say
LOL. Thanks. It's the GTR's that will give us 5ATs a run for our money with their new transmissions. We should have a couple GTRs out at the airstrip event this year, so it'll be interesting to see if they mop up or have some trouble given the high hp 6MTs out there now.
 
  #142  
Old 04-19-2009, 01:34 PM
rcdash's Avatar
Registered User
Thread Starter
iTrader: (4)
Join Date: Oct 2004
Location: NC
Posts: 2,173
Received 32 Likes on 26 Posts
Originally Posted by Boggess
Hi Raj,

Very, very nice set up! Thank you for sharing your 5AT TT beast with us! I have a similar set-up built by Forged, but with not near as much rwhp. Dylan did an exceptional install, and of course, Sharif tuned every horse he could squeeze out of her.

I'm now looking into improving the performance of my 5AT tranny. Forged did the valve body upgrade when the turbos were installed, but the turbos spool up so fast that my tranny won't shift from 1st to 2nd most at WOT. In 1st gear, the engine usually hits the rev-limiter before the transmission can shift. Do you have any advice that could improve this situation?

I haven't seen any viable solutions to this issue on the forums, other than replacing the entire transmission. Any help would be greatly appreciated.

Thanks,
-John
Thanks John. It's great to see more 5AT with FI on the road! In regards to the 1-2 shift, I honestly never floor it in first gear because even my 295 PS2 summer tires can't hold that level of torque. Remember we have a very steep first gear as well as 2x torque multiplication for about the first 50 ft on a launch thanks to our torque converters. There's just no freaking way a street tire will hold. I'm switching to 305/30R19 R888 and I'm prettyr sure they won't hold first gear WOT launches either. Our first gear ratio is just too steep for a FI motor, plain and simple. You are in worse shape because your torque peaks so much earlier with the 530bb.

That said, feathering the throttle with a TC isn't easy. Too little and you will bog, too much and you will spin the tires and hit the rev limiter. What I have found works reasonably well is to just perform the 1-2 shift earlier in MM mode - say 6k rpms and raise the rev limiter (for me it's at 7200 rpms). I also decrease boost to wastegate pressure until the car reaches 25 mph. Of course, you need a standalone like the Haltech to configure launches like that...

In D mode, I guess you'd just have to let up as you approach redline...
 
  #143  
Old 04-20-2009, 09:42 PM
Boggess's Avatar
Registered User
Join Date: Dec 2006
Posts: 15
Likes: 0
Received 0 Likes on 0 Posts
Thanks for all the info Raj! I hope to check out your G in person at Zdayz.
 
  #144  
Old 04-21-2009, 09:43 PM
rcdash's Avatar
Registered User
Thread Starter
iTrader: (4)
Join Date: Oct 2004
Location: NC
Posts: 2,173
Received 32 Likes on 26 Posts
You are welcome and I'm looking forward to seeing more folks FI with 5ATs out there. All the FI guys get lost in the swarm of NA cars though. We need to have badges that identify us as FI or NA and 6MT vs 5AT. That would be sweet!
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
911Turbo
19 Inch
10
08-24-2016 08:31 AM
netcbc
Exterior - Body Parts CDN
2
08-21-2015 09:50 AM
VANST3R
Lights
2
07-27-2015 08:20 PM
laksjd84
Exterior - Body Parts
1
07-24-2015 05:12 PM
Chattzx
The G-Spot
1
07-17-2015 11:23 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Forged Performance: rcdash's twin turbo G35



All times are GMT -4. The time now is 11:18 AM.