RLQ:

Anyone know what sizes of wires are used in the engine bay? I'm trying to get this wire tuck DIY PERFECT...

 

^What do you mean "what sizes"

 

Maybe what gauge for extending some wires. Not sure tho. Any similar wire will work.

 

gauge size. Still gathering everything up for my OCD wire tuck.

i wont do "similar" I want this to be as close to OEM spec as possible...I'm OCD like that

 

^Well, from what I hear, the main harness can be done without extending any wires.

I've only tucked the passenger side fender so far, and I needed to extend ground wires, but I made a couple short 10AWG straps to do so.
If you're going to extend them, you're better off to go with 'better than' oem

Other than that though, AWG is normally printed on the wire jacket.

 

The main can be done without extending wires but the mess that will be left behind the plenum will drive me insane. I'll check when I wake up this afternoon. If I can't see it, I'll be back

 

and btw...

what the hell is up with your avatar?!

 

^I was trolling for teh lulz... and, let's just say... it got Graced by a mod who shall remain "anonymous"

 

^ lol

 

Lmao .. ^^ ashley and his avatars.

 

better you than me.

 

 

I think I'll just wait for your DIY before starting mine then

 

does the coupe middy fit the X? Also what Y pipes fit (aftermarket/Z/etc)?

 

Ok guys hope you could help me out with a tire question

I have a 04 sedan on stance coil overs and soon to be getting front and rear camber kit

I am looking to get some new tires for my Hp 19 x 8.5 rims. I currently have 245/35/19 and I am looking for something with a little bit of a stretch and try to get flush

Hope you guys could help help out

(also posted this in the wheel and tire section, posting here to get some other feed back)