Random Little Question Thread
#3601
ill Sedan
iTrader: (87)
#3602
^How the heck!? I have a 2.5" projector and looked at putting it in the turn signal, and it was not even CLOSE. I don't think I could have trimmed the housing enough to get it close to fitting.
I wonder if the difference in the 03/04 blinker housing and the 05/06 is actually that much different?
I wonder if the difference in the 03/04 blinker housing and the 05/06 is actually that much different?
#3603
ill Sedan
iTrader: (87)
#3606
Registered User
iTrader: (85)
I was able to grind one down enough to fit....after about an hour of grinding, I nicked it a little and just gave up because I wanted no scratches
I used a grinding stone on my dremel.
^How the heck!? I have a 2.5" projector and looked at putting it in the turn signal, and it was not even CLOSE. I don't think I could have trimmed the housing enough to get it close to fitting.
I wonder if the difference in the 03/04 blinker housing and the 05/06 is actually that much different?
I wonder if the difference in the 03/04 blinker housing and the 05/06 is actually that much different?
So yeah, I gave up and did this.
Used some chrome rings out of a Maybach finishing kit (inside joke to Marcus ) and hacked up a set of projector fog lights
I still have to do the other side and get them installed. May add some demon eyes behind them as well
#3607
interesting...I have an 06 sedan and been wanting to do this for some time now. I may go this route. 2 questions though, Did you have to dremel the projector lens at all or just the housing? And what kind of glue did you use? I don't suppose super glue cause that stuff leaves residue behind, no? I appreciate any help.
#3609
Registered User
iTrader: (85)
interesting...I have an 06 sedan and been wanting to do this for some time now. I may go this route. 2 questions though, Did you have to dremel the projector lens at all or just the housing? And what kind of glue did you use? I don't suppose super glue cause that stuff leaves residue behind, no? I appreciate any help.
#3611
To avoid the "springmount mod", what do you guys think of running Z Htechs in the front and unRevised Z springs in the back on Tokico Dsp9's? It's probably not a good idea to mix linear and progressive springs but it will give the appearance of a more even drop than just the htechs alone. What you think?
#3613
ill Sedan
iTrader: (87)