^Forgetting the projector retrofit? My car looks much different than your average G35 when running headlights only

 

I want... lol

 

what would happen if you only replaced one cat with a test pipe

 

Ok.. So I had the arm rest down in the rear seat for about two weeks. When I lifted it up, there was a pretty bad impression from the lower part of the seat belt that was under the armrest... Will this go away? It looks pretty bad

 

Well, whichever side you replace, that side is going to have slightly more power and thus cause the car to pull toward the other side, so you're probably better to replace the Driver's side, so that if anything, your car pulls to the right instead of into oncoming traffic...






























.........



Maaaybe... Your best bet would be to soak it down in a good leather conditioner like Lexol, and let it sit in the hot sun for a while, repeat as needed.

 

Or have individually controlled cutouts on each side, that way you can turn your car by switching cutouts.


Just like those military tanks.....

 

My brembos want bigger rotors...what's the largest i can get for the oem brembos?

 

Is the ester also recommended for the Rev-up motor or is it only recommended for HR and later motors?

Thanks!

 

Don't waste your money, it shears quickly and not worth the money

 

Is there a "Look what I want" thread?

 

coupes are eww.. fastbacks only..

 

Im thinking about getting 8000k headlights. D2R is the size. When I buy new HID lights, i just have to buy replacment bulbs right? my current 4300k stock still work, just looking to switch temps.

And how do you replace the bulbs in g35 headlights. Do I have to pull the bumper forward and unscrew the whole headlight?

 

^I wouldn't go over 6000k if I were you.

You can either pull the bumper and take the lights out, or access the back of them through the fender by taking the front part of the wheel well liner loose.

 

yep, remove bumper, unscrew headlights, just a bulb replacement.

if you do your fogs just add a ballast n HID bulb and if you got a decent kit, it should be plug n play...

 

After reading this I realized that the Rev-up and HR aren't interchangeable... can anyone fix my confusion? Is this(below) correct? Anything significant I'm missing?! kinda feel like an idiot right now lol

Rev-Up: 7.1k b4 redline, More HP than non rev-up?
HR: dual intake, More HP than DE?