Random Little Question Thread
#8791
Searched (a little) and didn't find anything besides this thread. If I were to get OEM 19's to replace my current 17's, would I have to get the fenders rolled? My car isn't dropped.
Edit: Failed to see this was in the sedan section, duh. Sorry.
Edit: Failed to see this was in the sedan section, duh. Sorry.
Last edited by DeBlaca; 03-17-2013 at 08:21 PM.
#8793
I'm installing a MD 5/16" spacer and was wondering if anyone else had a problem getting the studs out of the plenum. The 4mm was too big and started round off the top of the stud. The instructions said something about using both nuts to get it off, but I'm not sure what they did to get it off. If anyone knows what I can do to get them out that would be much appreciated.
#8794
#8796
I'm installing a MD 5/16" spacer and was wondering if anyone else had a problem getting the studs out of the plenum. The 4mm was too big and started round off the top of the stud. The instructions said something about using both nuts to get it off, but I'm not sure what they did to get it off. If anyone knows what I can do to get them out that would be much appreciated.
#8797
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,299
Received 1,486 Likes
on
1,221 Posts
G35 sedan w/ too much money in mods
#8798
vice grips didn't work. and how do I use the bottom one to unscrew the stud? I did what the instructions said putting one upside down and the other right side up on top of it but when I tried to undo it it just backed off both nuts and didn't budge the stud at all
#8799
The following users liked this post:
thegreatkwijibo (03-19-2013)
#8801
#8802
Registered User
iTrader: (18)
Join Date: Sep 2007
Location: Auckland, New Zealand
Posts: 10,359
Received 1,939 Likes
on
1,249 Posts
The following users liked this post:
DVG (03-22-2013)
#8803
#8804
Registered User
iTrader: (18)
Join Date: Sep 2007
Location: Auckland, New Zealand
Posts: 10,359
Received 1,939 Likes
on
1,249 Posts
The following users liked this post:
DVG (03-22-2013)
#8805