Looks good ^ I'm happy with LED In my rear housings tho, much less cutting involved !

 

your brave those winter wheels in NJ

 

.cakester that looks amazing let me know if you make more I'd buy the inner led board from you

 

Not brave, stupid and impatient.

 

Be careful it's snowing

 

He has them, you have to cut the tails though as they use a permanent seal type holder to keep the two ends sealed together. He designed his own boards and soldered his own LEDs!

 

So how difficult is that

 

there are some guides to follow. its not all that hard. basically just following along the edge with a dremel wheel. good place to start:
https://g35driver.com/forums/lightin...aillights.html


I need to redesign the lens diffuser still, if you study the oem lights vs mine the oem ones have the light broke up a little more, looks more like little squares

 

i need to stop buying ****

 

SPL control Arm ???

 

front camber arm and rear midlink, been looking for the rear camber arms but havent found any used. im running the kw v2's so its oem style with the spring bucket. wanted to keep the oem style setup so i opted for the spl midlink upgrade

 

Any benefit to the midlink upgrade I'm also running the KW Varient 2s

 

you can use an eccentric lockout on the spring bucket which will allow you to adjust the toe and no chance of the toe going out of spec.

 

Tested UpRev ARC burnout mode..

 

Hehe..looks nice guys. So UPREV has an update?