Rubber Door Molding
#16
Ok folks I have an update on my issue. I brought my car back to where I bough my car in to the Willowdale dealer and the sevice advisor said it is covered under warranty. He took down my info and created a work order for me and will contact me when the part comes in. I was there for less then 10 mins. He also mentioned to me that this is very common and they have replaced a lot under warranty. So whoever has the same issue as me just bring it in.
I'm glad my dealer is willing to replace it under warranty.
I'm glad my dealer is willing to replace it under warranty.
#18
Originally Posted by lepricon
Hey Guys,
I just had the same thing happen. I went to both Yorkville and Alta and they told me that it was NOT covered under the warranty. They said that it was common for this piece to fall off. It was around $80 for a new piece if I remember, plus the cost to paint it to match your car.
Hope this helps
Dave
I just had the same thing happen. I went to both Yorkville and Alta and they told me that it was NOT covered under the warranty. They said that it was common for this piece to fall off. It was around $80 for a new piece if I remember, plus the cost to paint it to match your car.
Hope this helps
Dave
#20
Joined: Jan 2004
Posts: 21,095
Likes: 47
From: Toronto, GTA north
#21
I got the rubber molding replaced today. They told me that they are not going to spray or put my car through the car wash because it is way below -13 today. Service Advisor mentioned to me if it is below -10 dont wash our cars as the windows can shatter and door locks can get frozen.
Last edited by white_gts; 01-25-2007 at 08:40 PM.
#24
#26
I just noticed this problem today too.
I was cleaning the bottom of the door from the inside with a microfiber cloth, and I think I applied too much pressure (although it wasn't very much pressure at all) as I ran the cloth across the bottom edge of the door. I then checked the other door and noticed I had the same problem there too. The rubber/plastic is pretty brittle and frail, and it wasn't frigid outside when it happened.
here's a pic. I am going to seek replacement parts under warranty. Thanks for the info guys - when I saw the problem on my car I just KNEW someone else had probably posted about the issue too. I love G35 Driver!
I was cleaning the bottom of the door from the inside with a microfiber cloth, and I think I applied too much pressure (although it wasn't very much pressure at all) as I ran the cloth across the bottom edge of the door. I then checked the other door and noticed I had the same problem there too. The rubber/plastic is pretty brittle and frail, and it wasn't frigid outside when it happened.
here's a pic. I am going to seek replacement parts under warranty. Thanks for the info guys - when I saw the problem on my car I just KNEW someone else had probably posted about the issue too. I love G35 Driver!
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM
Extreme Dimensions
Southern California
3
10-19-2015 06:28 PM
Paragham
Interior & Exterior
9
09-15-2015 12:04 AM