Drivetrain Questions and info regarding transmissions, clutches, etc.

RPM's at 80 MPH

Thread Tools
 
Search this Thread
 
Rate Thread
 
  #331  
Old 01-11-2010, 11:18 AM
Tollboothwilley's Avatar
Former G35driver Vendor
Thread Starter
iTrader: (32)
Join Date: Jan 2008
Location: Vegas
Posts: 3,684
Likes: 0
Received 25 Likes on 17 Posts
Originally Posted by alfhasg35
2005 6MT Coupe with new motor under 200miles..


3100rpm at 80mph in 6th gear...
Originally Posted by speeddream
I remembered to look at my rpm's finally. So last night i noticed that at 81 mph i was at 2900 rpm's. 03 6mt sedan
Look at the diff. Both 6MT with the same FD but off by 200 rpms. 200 rpms is typically the diff between 3.3 and 3.5 FD
 
  #332  
Old 01-11-2010, 03:27 PM
alfhasg35's Avatar
Registered User
iTrader: (78)
Join Date: Feb 2005
Location: Orange County, 714, 92780
Posts: 3,268
Received 295 Likes on 183 Posts
where do you look..? and how...?

Originally Posted by Tollboothwilley
Look at the diff. Both 6MT with the same FD but off by 200 rpms. 200 rpms is typically the diff between 3.3 and 3.5 FD
my car is bone stock as far as the FD .... so..?
 
  #333  
Old 01-11-2010, 04:21 PM
OCG35's Avatar
Registered User
iTrader: (33)
Join Date: Nov 2004
Location: OC - So Cal
Posts: 17,181
Received 154 Likes on 112 Posts
Originally Posted by Tollboothwilley
Look at the diff. Both 6MT with the same FD but off by 200 rpms. 200 rpms is typically the diff between 3.3 and 3.5 FD
its not uncommon for the tach to be off by that much though... I dont know about being off to another car - but off from actual rmps (as noted on several dyno pulls)...
 
  #334  
Old 01-11-2010, 04:25 PM
NFSP G35's Avatar
? = 2B || !2B

iTrader: (22)
Join Date: Apr 2009
Location: Tallahassee, FL (or thereabout)
Posts: 22,160
Received 851 Likes on 639 Posts
My tach is off by about 50 RPM if I'm cruising. But if I floor it, the tach does 'lag' behind the real RPM. IDK by how much. I'd have to datalog to see.
 
  #335  
Old 01-11-2010, 04:36 PM
Tollboothwilley's Avatar
Former G35driver Vendor
Thread Starter
iTrader: (32)
Join Date: Jan 2008
Location: Vegas
Posts: 3,684
Likes: 0
Received 25 Likes on 17 Posts
ya, that can happen. Sometimes the tachs are not very accurate. Plus, you have to get the rpm while you are on flat ground.

I'm sure you have the 3.53 Final Drive differential it just shows you how they can be off.
 
  #336  
Old 01-11-2010, 05:12 PM
Jeff92se's Avatar
Red Card Crew

iTrader: (24)
Join Date: May 2005
Location: ɐʍ 'ǝlʇʇɐǝs
Posts: 37,810
Received 583 Likes on 496 Posts
Won't it depend on the tire dia also? Even with the same tire size, the actual dia various amount different makers.
 
  #337  
Old 01-11-2010, 05:18 PM
OCG35's Avatar
Registered User
iTrader: (33)
Join Date: Nov 2004
Location: OC - So Cal
Posts: 17,181
Received 154 Likes on 112 Posts
^^^ speed yes, rpm no.
 
  #338  
Old 01-11-2010, 05:19 PM
NFSP G35's Avatar
? = 2B || !2B

iTrader: (22)
Join Date: Apr 2009
Location: Tallahassee, FL (or thereabout)
Posts: 22,160
Received 851 Likes on 639 Posts
Originally Posted by Jeff92se
Won't it depend on the tire dia also? Even with the same tire size, the actual dia various amount different makers.
^That post kinda sounds like you're saying dire diameter would affect your RPM or make your tach read wrong. I know what you mean though. Changing tire diameter would change the ratio between RPM and actual speed. It shouldn't change the ratio on the dash though since the speedo works off the tire RPM (independant of speed/tire size) but if your were compairing RPMs to speed on a GPS then it would.
 
  #339  
Old 01-11-2010, 05:25 PM
Tollboothwilley's Avatar
Former G35driver Vendor
Thread Starter
iTrader: (32)
Join Date: Jan 2008
Location: Vegas
Posts: 3,684
Likes: 0
Received 25 Likes on 17 Posts
tire size will affect the RPM slightly, but should be no more that +/- 50 rpm. Smaller diameter tires will change the true speed of the car - thereby affecting the RPM at that given speed.

^^ same thing you were saying i think haha, repost.
 
  #340  
Old 01-11-2010, 05:30 PM
NFSP G35's Avatar
? = 2B || !2B

iTrader: (22)
Join Date: Apr 2009
Location: Tallahassee, FL (or thereabout)
Posts: 22,160
Received 851 Likes on 639 Posts
^Add to this the fact that you could have a +/- 100 RPM inaccuracy in the tach combined with a +/- 5 MPH inaccuracy in the speedometer... and if they're inaccurate in opposite directions... well, you get the idea.

Really the best way to get an accurate reading is with datalogging software showing your true RPM and a GPS to show your true speed.
 
  #341  
Old 01-12-2010, 12:17 AM
Tollboothwilley's Avatar
Former G35driver Vendor
Thread Starter
iTrader: (32)
Join Date: Jan 2008
Location: Vegas
Posts: 3,684
Likes: 0
Received 25 Likes on 17 Posts
This is why cruise control is disabled with a different FD (it has to do with the TCU)

Name:  CruiseControl.jpg
Views: 88
Size:  90.2 KB
 
  #342  
Old 01-12-2010, 12:48 PM
DaveB's Avatar
Registered User
iTrader: (9)
Join Date: Aug 2003
Location: Kansas City
Posts: 6,573
Likes: 0
Received 72 Likes on 51 Posts
Toll- I'm assuming your CC is still working below 79mph?
 
  #343  
Old 01-12-2010, 02:30 PM
OCG35's Avatar
Registered User
iTrader: (33)
Join Date: Nov 2004
Location: OC - So Cal
Posts: 17,181
Received 154 Likes on 112 Posts
does yours work Dave?
 
  #344  
Old 01-12-2010, 02:58 PM
DaveB's Avatar
Registered User
iTrader: (9)
Join Date: Aug 2003
Location: Kansas City
Posts: 6,573
Likes: 0
Received 72 Likes on 51 Posts
Originally Posted by OCG35
does yours work Dave?
Haven't installed it yet. Might be another week or two.
 
  #345  
Old 01-12-2010, 06:49 PM
Tollboothwilley's Avatar
Former G35driver Vendor
Thread Starter
iTrader: (32)
Join Date: Jan 2008
Location: Vegas
Posts: 3,684
Likes: 0
Received 25 Likes on 17 Posts
Yes, my CC works, and it works all the way up to 86 MPH.
 


You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: RPM's at 80 MPH



All times are GMT -4. The time now is 04:34 PM.