Can anyone tell me if this sub will fit in our rear deck?

http://www.crutchfield.com/s_130SW84...1D.html?tp=111

 

That's good to know as you are local as well. How long does it take you to drive 4-5K?

You use the rear diff and/or the front middle area to jack up the car [with a scissor jack] for a flat tire?

 

^ Those are not the only factory locations; there are two on each side, one front one rear on the pinch welds.

 

Really? I'll have to look at the service manual again. I put my jack stands in the pinch welds.

 

Well they call the front and rear the 'garage jack points' and the pinch welds as the 'safety stand points':



So you're correct to do that BUT I don't know if I'd trust the scissor jack under the front and back points on anything less than a perfect surface (and even then...)

 

^ Yea scissor jacks will go on the pinch welds, Floor Jacks go on the Central Jack points (Diff and front nipple)

I would never try using a scissor jack on the Central Jack points ha.

 

hey guys i asked what were good brake pads for the stock brakes on a 2003-2004 sedan someone told me hawks does anybody have a link or other suggestions also can someone explain how they zip tie there corner lights(side markers)

 

bump

 

I have hawk hp, almost no dusting at all.

 

do they stop as well as OEM

 

I never measured but I feel like they do. I know they say there is a drop off...

 

thanks for the help i need to change my pads and i dont know what to get OEM stopping is really good IMO and i wanna keep that and not have as much dust or any noise

 

Can anyone refer me to tony for the oem pads

 

tony does not work at river side any more, Rick does. There is also Tim@grubbs I ordered from him and 5 min later they were shipped

With OEM you will get the best initial bite, Less dust = less grip

 

^But the 03/04s suck.
Sure they bite good, but they dust SOOOOOO bad. It's unbelievable