Well they don't show on that site the size that fits the G. 5X114.3. The only ones I saw were 5X100 and 5X112.

 

what the hell is A-disk O-disk ...ect? IM hella confused

 

^ it's how high the pad is for brake clearance.
work wheels goes by disks: R, A, and O.

 

what has the most hight? R?

 

^ R and T for BBK clearance.

 

Got the clearance Clarance?

 

is that the correct offset for these wheels all around ??

 

yes

 

Hey Rob, what kinda spacers were u running in the fronts with the all black t1s that you had before? Tryna get em more flush but without scraping the sidewall :P

 

Hi All,
I'm planning on getting some Stern ST7 wheels. Just wanted to know what kind of offset I should get to make it look somewhat flush.

Here's info so far: 2003 Coupe Sport non brembo lowered on 350z Tein H-techs

Wheels are: Stern ST7 19x8.5 front and 19x9.5 rear.

What kind of offset should I get?
20mm, 25mm, 35mm, 38mm?

I've searched here, 350z forums, and found tons of different answers but just want wheels that I don't have rubbing issues or have to do any kind of fender rolling. Thanks again and sorry if this has been asked a million times.

 

Hmm, from the calc's I've been playing with
"Package will stick out 28 mm (1.1'') farther. Make sure that you have enough room under the fender. If not, consider narrower tires or higher offset. "

http://www.wheelsmaster.com/rt_specs.jsp

So I'm not sure why you say it will be sunken in, please clarify.

"More like upgraded OEM wheels" is fine with me..

 

lookin for some opinions.. goin to to go for the aggresive streached tire set up and i am stuck on what to do about offsets. i'm goin with the weds kranze vishunu wheels doing a 20x10 front and 20x11 rear want to run the 35 series tire. im on stance lk coil overs now but want to go as low as poss. (within reason)on this set up.... can anybody help??? thinkin the singal digits for offsetbut dont want to over kill i can alway add spacers to make up but want to get as close as possible. of course rollin my fenders flat.....

 

Anyone know of a place that I can get replacement barrels/hoops for a 2 piece Iforged wheel. I want a larger lip then I have now?

 

hey shane was wondering if you can give me a heads up on this im planning to run a 20x10 0 in the front and a 20x11 -5 in the rear. i want aggresive but was wondering if its to much to go with i understand that when i drop my car ill have to do a roll and a pull but is it a major pull? and the camber will b in the neg. and i need to aline it correctly but after all is said and done will there still be big neg. camber to where ill go through tires lk crazy. please let me know if possible thanks bro

 

Ok need some help with some clearance for a BBK kit.
On stock brakes right now and if i brake at high speeds wheel shakes and me no likey that. Looking for a slight upgrade, like akeebono's or sumthin. Tryna figure out which BBK i can run (i hope i can run em) that'll clear my wheels.
Current wheel set-up is work t1s 225/35/20 9.5 +7 R disc in the fronts and 255/35/20 10.5 +0 O disc in the rear. Can i run Akeebono's and not have any clearance issues? Tryna run any kinda upgraded brake kit. Brembo's or whatever.