DIY: 5AT to 6MT SWAP.
#181
#182
#183
As for now, I am going back to 5AT engine harness, but the engine harness include the transmission sensors etc.
For those who used the Automatic Transmission harness, did you simply left those manual transmission connectors unplugged or you did something special?
Thanks.
For those who used the Automatic Transmission harness, did you simply left those manual transmission connectors unplugged or you did something special?
Thanks.
#186
Car lags on starting
Did anyone have problems turning on the car.
It cranks all the time and it will always turn on but sometimes it takes more times than others..
Has new crank/cam sensors, spark plugs and battery.
Car runs great.
I only wired in the ingnition to the clutch and to the gray/red wire.
-was there anything else that i have to wire ? Or was something done wrong?
It cranks all the time and it will always turn on but sometimes it takes more times than others..
Has new crank/cam sensors, spark plugs and battery.
Car runs great.
I only wired in the ingnition to the clutch and to the gray/red wire.
-was there anything else that i have to wire ? Or was something done wrong?
#189
#190
#191
#192
mine works normally. only thing I can think of is if it is cold it will idle higher until it hits normal temps.
Do you have the 6mt gauge cluster in your car? I can't get it to work properly in mine. Gauges work fine but dome lights and auto headlights off etc dont work as it seems to be messing with the door open signal
Do you have the 6mt gauge cluster in your car? I can't get it to work properly in mine. Gauges work fine but dome lights and auto headlights off etc dont work as it seems to be messing with the door open signal
#193
mine works normally. only thing I can think of is if it is cold it will idle higher until it hits normal temps.
Do you have the 6mt gauge cluster in your car? I can't get it to work properly in mine. Gauges work fine but dome lights and auto headlights off etc dont work as it seems to be messing with the door open signal
Do you have the 6mt gauge cluster in your car? I can't get it to work properly in mine. Gauges work fine but dome lights and auto headlights off etc dont work as it seems to be messing with the door open signal
#194
quick question
Not exactly sure where to post this, but I wanted to try to get a quick response.
I have a 2004 Coupe with 104K miles and a Stillen supercharger (installed by previous owner around 85K). My clutch and flywheel have been going out over the last couple of months, and it is do or die. I bought the Jim Wolf Clutch and Flywheel, but I'd like to replace the rear main seal on engine and front transmission seal & gasket. Does anyone know what the part numbers/names are for those seals/gaskets??
(Not doing the work, personally, but I'm trying to buy all the parts.)
I have a 2004 Coupe with 104K miles and a Stillen supercharger (installed by previous owner around 85K). My clutch and flywheel have been going out over the last couple of months, and it is do or die. I bought the Jim Wolf Clutch and Flywheel, but I'd like to replace the rear main seal on engine and front transmission seal & gasket. Does anyone know what the part numbers/names are for those seals/gaskets??
(Not doing the work, personally, but I'm trying to buy all the parts.)
#195
Help
Will getting a 6mt ecu work with the 5at engine harness?
Any help from anyone would be greatly appreciated! All I have left of this project is to start the car